0
What else can I help you with?
Would your car blow oil if it had a bad PCV Valve?
Yes. Remove it, shake it. It should make a rattling noise. It could be plugged up. Just install a new one. They only cost about 10 dollars.
What would labor cost be to install float valve in toilet?
The labor cost to install a float valve in the toilet will depend on the hourly wage of the plumber. The part should take no longer than a hour to replace.
How much will it cost to fix an idle valve in your car?
It would cost $725 bucks
What does water reducing pressure valve costs to install?
The cost to install a water reducing pressure valve typically ranges from $150 to $500, depending on factors such as the type of valve, labor costs in your area, and any additional plumbing modifications needed. Installation usually takes a few hours, which can also impact the overall cost. It's advisable to get quotes from multiple plumbers to ensure a fair price.
How much does it cost to have someone install a toliet?
I would say about $600 to install a toilet. :d
How much does it cost to have a plumber install a gas shut off valve for a dryer?
$860 plus filing fees.. Testing of course is included
How much would it cost to install vertical doors on a 2000 convertible camaro?
To install them it would be about $1000.00 to $1500.00 but your car would be bout $1300.00....
How much would it cost to install an entry door and a storm door?
hey it would cost approximately $80 000!
How much would it cost to install a universal muffler?
for about 60 bucks.
How much does it cost to install air bags for a 1998 Chevy Malibu?
how much would it cost me to have Chevrolet install a steering wheel air bag if i bring one in
How much would it cost to replace a blowin headgasket on a 1997 Lumina?
What is the avearage cost to fix a blow headgasket on a 98 lumina
What would cause oil to be lying on engine of 1984 Toyota pickup?
Well to start with it's not unusual for an older engine to have several oil leaks due to aging gaskets. On top it is probably a valve cover gasket but the first thing I would check is the pcv valve. If it is stuck (doesn't rattle when you shake it) it will cause pressure to increase in the crankcase forcing the oil through the gaskets. That would be about a 5 dollar fix. Next check the cap where you add oil and see if the gasket on it is still good. With that cap removed, start the engine and see if you have a lot of pressure there called "blow by". Blow by is caused by a bad PCV valve or worn piston rings and valve guides. If the rings and valve guides are worn enough to cause significant blow by you will eventually have to rebuild the engine. On a 1984 Toyota it probably doesn't make much sense to rebuild the engine. The cost would be more than the truck is worth unless it has some sentimental value to it. Good luck.
