IS RCA BLEND A GOOD BASE FOR ASPHALT DRIVEWAY?

When is the best time to fill asphalt driveway cracks?

When its hot, anywhere above 70 degrees would be good. If its cold it won't bond, or it will crack sooner.

How to Cleaning Antifreeze stain off driveway?

Stain on asphalt can be removed with a good grease removing household cleaner. For concrete, the stain may have to be removed with muriatic acid.

When do I sealcoat a new resurfaced driveway?

It takes approxamately 90 days for new asphalt to fully cure... It is recommended to seal your new asphalt any time after the 90 day mark, but within a years time. After that, you should be good for 3-4 years before you need to re-seal.

How much weight will a blacktop driveway hold?

That is a tough question. I assume you are asking how heavy can your vehicle be? Residential driveways are made to support passenger cars and light delivery trucks. They are not made to support the weight of heavy commercial trucks. The load-bearing capacity of a typical driveway depends on the soil beneath the driveway, the driveway's foundation (amount of gravel below the asphalt), age of the driveway, the moisture content of the ground, thickness of asphalt, the particular mix of asphalt used and the ground temperature. The typical well built driveway will have 2`` - 3`` of asphalt plus a 4" substrate of gravel. To get some idea of how much weight should be allowed on your driveway, maybe the State load limit is a good reference point. In California the law says: ``The gross weight on any one axle shall not exceed 20,000 pounds, and the gross weight upon any one wheel, or wheels, supporting one end of an axle, shall not exceed 10,500 pounds.`` What that means is a truck with four wheels weighting more than 42,000 Lbs is not allowed on any streets in California. That maximum load is for City/State streets. Those streets are usually built many times stronger than residential driveways. Using that as a gauge, you can decide how much risk you want to take by allowing a heavy truck on your driveway. If I was to make a call, I would not allow a four wheeled truck weighing any more than 10,000 Lb on my driveway. Any more than that and you are likely to get damaged asphalt.

What is the average cost of laying a new asphalt driveway?

Current rate 1.50/square Foot. 8-22-08 HOW MUCH FOR A 33 X 33. NEED TO TAKE OUT EXISTING DRIVEWAY.(DIRT) The current rate in Texas is between $3.00 and $4.00 a square foot. To install new asphalt at approx. 2 inch depth. You will need to figure in the base and tear out of the old asphalt as well as disposal fees. Don't forget the price of gas. Diesel fuel is up pretty high. Oh and Uncle Sam too! This is if you want a reliable contractor. Some of the smaller freelancers will charge less and do good work too! Never advance more than 50% for the job. That is more than enough for any asphalt contractor to get the job done.

Can you blacktop over concrete driveway?

Yes, you can blacktop over a concrete driveway, but it requires proper preparation to ensure good adhesion and durability. The concrete surface should be clean, free of cracks, and ideally textured to help the asphalt bond effectively. It's also important to consider that the existing concrete may affect the final appearance and longevity of the asphalt overlay. Consulting with a professional can help determine the best approach for your specific situation.

Driveway Paving Options?

Generally, homeowners are judged by the exterior condition of their house, and the driveway that leads to the house. Driveway paving options are determined by: 1. The style of the house. 2. The general climate. 3. The financial position of the homeowners. Moreover, it is extremely important to care for the walkways, the patio floors as well as the driveways. The concrete or asphalt should be seasonally inspected to make sure there are no cracks, pitted or worn spots. Keeping the driveway in good condition requires regular care and the usage of proper tools. The suggested method would be to hire a reputable paving company to inspect and maintain the driveways. Asphalt, brick or colored stones can be used for driveways. Asphalt is the fastest and the easiest method and is usually used for newly built homes. Asphalt is easy to mix, pour and seal, and causes homes to sell quickly. However, this type of driveway is fragile in the heat, snow or freezing weather. The temperature causes the asphalt to display signs of wear and tear, and requires constant care. Stone or slate driveways add an elegant look to any driveway regardless of the cost of the house. The stones can be purchased in any size and shape, and are available in a variety of colors. Placing a sheet of plastic on a grass-removed path will keep the grass or weeds from growing through the separations between the stones. Bricks and slate can also be used for driveway paving. The bricks can be bought in white, red or a combination of them both. Bricks add a luxuriant look to the front of any home. Further improve a driveway by adding lighting to the walkway leading to the front door. Using the proper driveway paving options can easily add value to a home. The first thing noticed as guests or family approach the house is usually the driveway and how the paving looks. Generally, houses are widely judged by the following three items. 1. The cleanliness of the exterior of the house. 2. The attractive flower beds and a well-kept lawn. 3. The type, style and appearance of the driveway paving.

Is it good for rabbit's to walk on asphalt?

YES

Is asphalt waterproof?

The asphalt itself is, but if there are any cracks in as seems common, then water will get under. Cracks in asphalt can be sealed easily now with many good caulk products.

Is kerosene good to mix with ashphalt?

No, kerosene is not recommended to be mixed with asphalt. It can degrade the asphalt binder, affecting the overall performance and durability of the asphalt mixture. It is important to use recommended additives and mixtures for asphalt to maintain its quality.

Is asphalt a insulator?

Asphalt is a poor conductor of electricity and can be considered a good insulator for that purpose. However, it is not a good insulator for thermal energy, as it conducts heat readily.

What is a good unique name for a puppy boy?

asphalt