You can use silicone as a substitute, but plumbers putty is simpler and far easier to clean up. 100% SILICONE
No, putty is typically made from a combination of silicone oil and silica powder. Borax is sometimes used in DIY recipes for homemade putty, but it is not the main ingredient in commercially-produced putty.
Silicone and plumber's putty are both used for sealing plumbing fixtures, but they have different properties. Silicone is a flexible, waterproof sealant that is best for areas that may experience movement or vibration. Plumber's putty is a soft, moldable material that is better for creating a watertight seal on surfaces that are not subject to movement. In general, silicone is more suitable for sealing plumbing fixtures due to its durability and flexibility.
To seal a leaky pipe using silicone or plumber's putty, first clean and dry the area around the leak. Apply the silicone or putty directly onto the leak, covering it completely. Press firmly to ensure a tight seal. Allow it to dry completely before testing the repair.
Silly Putty is made by Crayola of different types of silicone. It was created by accident when scientists were trying to make a cheap rubber substance.
No, alien putty toys are not living creatures that can reproduce. They are typically made of silicone or similar materials for fun and entertainment.
No, liquid soap cannot be used to make silly putty. Silly putty is typically made from silicone polymers, which give it its unique stretchy and bouncy properties. Liquid soap does not contain the necessary ingredients to create a substance with similar characteristics to silly putty.
When installing a new sink, it is best to use plumber's putty for sealing around the drain and silicone for sealing around the edges of the sink. Apply a thin, even layer of plumber's putty to the drain flange before installing it, and use silicone to create a watertight seal between the sink and the countertop. Be sure to follow the manufacturer's instructions for both products to ensure a proper installation.
To effectively remove silicone, you can use a silicone sealant remover or a mixture of isopropyl alcohol and water. Apply the remover to the silicone, let it sit for a few minutes, then scrape it off with a putty knife or scraper. Repeat as needed until the silicone is completely removed.
No, plumber's putty should not be used on marble surfaces as it can potentially stain or damage the marble. It is recommended to use silicone caulk specifically designed for marble or other sensitive surfaces when installing faucets in marble sinks or counter-tops.
Starting with ordinary silicone rubber sealant add as much ultra-fine graphite powder as it is possible to get the sealant to absorb to make a putty. You will need to add so much that the putty will *almost* no longer be mouldable. Form the putty around a wire and leave to cure. You will now have a carbon rubber electrode. If it does not conduct you have not added enough graphite dust. As some silicone sealant contains fungicide this should not be used on the skin. Adding lighter fluid to silicone sealant thins it down. It may be possible to do this when making the putty to thin it down and get it to absorb more graphite powder. However I have not attempted to thin the mix in this way and as the lighter fluid stays in the silicone putty after curing *never* use this when skin contact is intended.
To effectively remove dried silicone, you can use a silicone remover or solvent to soften the silicone, then scrape it off with a putty knife or scraper. You can also try using rubbing alcohol or vinegar to break down the silicone. Be sure to follow safety precautions and test a small area first to avoid damaging the surface.