the load above it may be too heavy to support and the structure could collapse.
A wall bearing no load.
Usually, a load bearing wall will be perpendicular to the roof ridge.
Load Bearing - something that bears a load. Like a load bearing wall in a house. The wall is holding something up like the roof, another floor, etc.
Yes, you can run electrical wires in a load bearing wall.
A load-bearing wall is a structural wall that supports the weight of a building or structure above it. It is essential for the stability and integrity of the building. On the other hand, a non-load-bearing wall is not responsible for supporting any weight and is primarily used for dividing spaces or for aesthetic purposes.
A load-bearing wall itself will not cause structural damage. However, if a load-bearing wall is removed without structural replacement, yes structural damage will occur.
A load bearing wall supports a structure or weight that is above it, transferring that weight to what is below the wall. Also - The most common, as easiest to identify is the exterior wall.
To determine if a wall is load-bearing from the attic, look for vertical supports that run from the ceiling to the floor below. These supports indicate that the wall is likely load-bearing and should not be removed without professional guidance.
A load-bearing wall is a structural wall that supports the weight of a building. It is typically thicker and made of stronger materials than non-load-bearing walls. To identify a load-bearing wall in your home, look for walls that run perpendicular to the ceiling joists or rafters, as they are more likely to be load-bearing. Additionally, consult a structural engineer or contractor for a professional assessment.
You will need to go to the level above the wall. If girders, joists or another wall is supported by your initial wall, then that becomes a 'load'. Supported by by the wall downstarirs, Thus bearing a load
To determine if a wall is load bearing, you can look at the wall's position in relation to the structure, check for beams or columns above it, and consult a structural engineer if unsure.
The recommended spacing for horizontal studs in a load-bearing wall is typically 16 inches on center.