answersLogoWhite

0

A Forstner bit drills flat bottom holes.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How can I drill a flat bottom hole?

To drill a flat bottom hole, use a drill bit with a flat end or a spade bit. Make sure the drill is set to a low speed and apply even pressure while drilling. Keep the drill perpendicular to the surface to ensure a flat bottom hole.


How do you drill a five sixteenth inch hole four inch depth flat bottom hole?

5/16 hole X 4 inch on a flat bottom hole: This will depend on the material, and tools available. Use a 1/8 bit, then 5/16. If you are not sure how deep the drill bit is in the hole, paint white out on the bit as your 4 inch mark so you can see it while the drill is spinning. If the material is metal, you will need coolant. To get the flat bottom: it wood, put a flat ended bolt into the hole and hammer, it will flatten the hole, it metal, forget about it, the hole is quite flat, and a pain in the butt to change. :-)


What is the bottom part of a pillar drill called?

It depends on what is meant by "bottom part" - does this refer to the entire machine, or the drill bit? See the related link below for a labelled diagram of a pillar drill.


What is flat bottom flask?

A flat bottom flask would be an Ehrlemeyer flask, which is used quite a lot by chemists.anf


What hull type if best used on ponds small lakes and calm rivers?

Flat Bottom Hull


What is drill vise?

It is a type of flat vice that fits on the table of a drill press or vertical drill, so it will hold small items while drilling them.


Which of these hulls is planing hull round bottom flat bottom multi hull catamaran?

the flat bottom i think


What is a flat area on the ocean bottom?

An abyssal plain is a flat area on the ocean bottom


What type of drill bit is commonly used for creating flat-bottomed holes in woodworking projects?

For creating flat-bottomed holes in woodworking projects, a Forstner drill bit is commonly used.


What can you say about flat tires?

They are only flat at the bottom.


What is a drill press vise?

It's a flat vice that clamps to the drill press table, to hold small items being drilled.


Does a cylinder have flat face?

The top and bottom are normally flat.