answersLogoWhite

0

What else can I help you with?

Related Questions

How many 6x6 inches shingles do you need to fill a 17x12 foot roof?

34 x 24 assuming no overlap.


Where do you start shingles on pyramid shaped roof?

Pretty much regardless of the shape of the roof, shingles should start at the bottom. If you don't, then they don't overlap right and it makes it easier for water to get underneath them, which is generally regarded as bad.


Sam wants to tile the roof of his shed with square tiles that are 4 inches square His roof is 12 feet by 12 feet How many tiles does he need?

If the tiels do not overlap (shingles overlap) one square foot will be covered by 3 * 3 = 9 tiles12 * 12 = 144 square feet144 * 9 = 1296 tilesSam should get at least 1300 tiles because he is sure to break more than 4!This assumes that the roof is square and flat.


Is it best to use valley flashing or shingle over the valley on roof?

shingle overlap when properly attached is best for valley water run-off


How many shingles to roof a 14 x 18 building?

That's going to depend on the size of each shingle, and how far you overlap the adjacent courses.


How to install a flat roof?

To install a flat roof, first, ensure the roof deck is clean and free of debris. Next, apply a waterproof membrane or roofing material, making sure to overlap seams and edges. Install flashing around any openings or edges. Finally, add a protective coating or finish to seal the roof and prevent leaks.


How to install a ridge cap on a roof?

To install a ridge cap on a roof, first, ensure the roof is clean and dry. Place the ridge cap over the peak of the roof and secure it with roofing nails or screws. Make sure to overlap the ridge cap pieces to prevent water leakage. Finally, seal the edges with roofing caulk for added protection.


How to install roof shingles properly?

To install roof shingles properly, start by preparing the roof surface, laying down a waterproof underlayment, and then starting at the bottom edge of the roof and working your way up. Nail the shingles in place, making sure to overlap them correctly and follow the manufacturer's instructions. Finish by adding flashing and ridge caps for a secure and weatherproof installation.


How much metal roofing do you need for a 10 x 20 foot roof?

That depends on the stock sizes of chosen material, necessary overlap, etc. The question as put is not answerable.


How do you install a metal roof drip edge?

To install a metal roof drip edge, first, measure and cut the drip edge to fit the length of the roof edge. Next, secure the drip edge along the eaves of the roof using roofing nails or screws. Make sure to overlap the sections of drip edge to prevent water from seeping underneath. Finally, seal the edges with roofing sealant to ensure a watertight seal.


Do hens have pimples on there legs like the roosters do?

Hens' legs are scaly and of a light colour. Sometimes dirt gets in between the scales. The scales are quite hard, and they overlap like the tiles on a roof.


How do you write overlap in the sentence?

I ama sitting overlap