A mean timber hip rafter is a structural member in a roof framework that extends from the ridge to the corner of the building, where two roof slopes meet. It supports the weight of the roof and helps to transfer loads down to the walls. The term "mean" typically refers to the average or typical dimensions used in construction, ensuring that the rafter is appropriately sized for stability and durability. In design, hip rafters are crucial for maintaining the integrity of hip roofs, which have slopes on all sides.
A Jack rafter is a rafter that has the pitch of the roof cut onto one end with a 54 degree angle this sort of rafter is one of several that fit onto a hip ridge. To cripple a piece of timber means to cut it partway through in order to straighten it if this is done to a wall timber it will need to be splinted to restore the strength of the stud
A broken hip rafter refers to a structural failure in a roof system, specifically involving the rafter that supports the hip of a hip roof. Hip rafters are angled beams that run from the ridge of the roof to the corners, providing support and stability. When a hip rafter breaks, it can compromise the integrity of the roof, potentially leading to sagging or collapse. Repairing a broken hip rafter typically requires replacing the damaged rafter and ensuring proper support is restored to the roof structure.
A cripple jack rafter is a jack rafter which touches neither a ridge rafter or a top plate. Cripple jack rafters are often categorized as either valley cripple jack rafters or hip cripple jack rafter.
half diagonal thickness of ridge
The run is on 17 not on 12 like you would use for a rafter.
what is timber conversion
Patrick Rafter's birth name is Patrick Michael Rafter.
I don't see why not. -Luke the carpenter
Hip or valley jack? In a hip jack, the stock is shortened 1/2 the 45 degree thickness of the hip rafter (1-1/16" for dimensional lumber). Then, another plumb line is brought half the thickness of the jack's stock (3/4" for dimensional lumber) back towards the seat cut. The centre of the stock is marked on the edge where the first plumb line comes down, and then the lines squared across the edge to give the shape of the cut where it meets the hip rafter. It's really only shortened once, the second line is to mark the shape of the cut. It appears to be 45 degrees, but really it's not...
depending how you spell it in Hebrew, it could mean rafter, beam, happen, write, or call.
To stop short and refuse to go on, or as a noun, A wooden beam or rafter.
Leonard Rafter was born in 1912.