0
What else can I help you with?
Can you drill an acrylic sink?
Yes, you can. Use a centre punch first so your drill bit doesn't 'skid' on the shiny surface.
Why do you sink the screws or nails used to attach drywall?
The nails or screw are sunk because you are going to sand the surface after the mud is applied. You don't want screw or nail heads to be near as they rip sanding paper.
What are the best practices for installing drywall nails?
When installing drywall nails, it is best to space them evenly, drive them in straight, and sink them slightly below the surface of the drywall without breaking the paper. Use the right size and type of nail for the job, and avoid overdriving or underdriving the nails.
Why do steel nails sink?
they are steel, steel sinks
Why Do Ships float and nails sink?
The general rule is that an object will sink if it has a greater density than the liquid in which it is placed.
Why do nails sink in water?
Because they are more dense than water.
What do you call a basement sink?
just a sink Below surface (grade) sink
Why does your fingers sink into oobleck but if you punch it your hand wont go through?
The reason why your fingers sink into oobleck is because they are there for a reasonable time for them to sink into it but but when you punch it you take your hand of straight away so it doesnt have enough time to sink into the oobleck and because your hands have to be in a small ammout of a size.
Why does a water spider not sink?
The answer is surface tension
How do you fasten Baseboards?
Some people use caulking to stick them on but this can lead to them falling off easily later on. Best way is to nail the baseboards in place. Use finishing nails. A stud finder will help locate wall studs to nail into. If you don't have one, then knock on the wall and listen for a hollow sound, this is where there is no stud. For neatness it is better to sink the nails below the surface. You can use a nail gun for ease or a punch to make them sink below the surface a little. For outside corners, apply a thin line of adhesive to mitered edges to ensure a better bond. You shouldn't need any adhesive on the inside corners when the ends are properly coped on the boards. Finish the holes by using filler and a scraper to take off the excess. Allow it to all dry before painting or varnishing.
Why do I sink in the pool?
When you sink in the pool, it is because your body is denser than the water. This causes you to displace water and sink below the surface.
Are sink holes constuctive?
sink holes are destuctive because it is breaking down the earth surface
