answersLogoWhite

0

No this is untrue. There are plenty that you can by that are meant to be clamped together. Also make sure you follow the instructions because welding a kit that was meant to be clamped together will void the warranty.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Can you install and run Microsoft Word on your computer without first installing an operating system?

No. You need an operating system to do the installing.


Do you have a diagram of a Mitsibishi Galants exhaust system?

usually you can get a print out of the exhaust system at advance or autozone.just explain you need to see the breakdown of the exhaust system to see what part of it you need. Discount auto parts were really good at this but since advance auto bought them I'm not sure anymore.


Would you need to remap the engine after fitting new exhaust headers?

It is recommended to remap most engines after installing performance parts. The benefit of remapping is getting the full benefit of the new exhaust headers.


Exhaust Systems?

form_title= Exhaust Systems form_header= Install a new exhaust system in your car. Does the existing system need to be repaired?*= () Yes () No How old is the exhaust system?*= _ [50] What is your budget for an exhaust system?*= _ [50]


Need a diagram of the exhaust system of a 1999 Nissan sentra gxe?

hey


You are changing your installing screamin eagle slip on mufflers to your 09 fat bob is there anything else that you need to do to the exhaust?

Take it to your HD dealer and have the eprom flashed.


Do you need to tune for an aftermarket exhaust?

To be safe yes, and also to get the most from the exhaust system you should. So I'll just say yes, you do.


How do you remove a factory exhaust tip on a Mazda 3?

To remove the factory exhaust tip on a Mazda 3, start by raising the vehicle securely on jack stands to access the exhaust system. Locate the exhaust tip, which is typically held in place by clamps or bolts; use a wrench or socket set to loosen and remove them. If the tip is welded on, you may need to cut it off using a reciprocating saw or exhaust pipe cutter. Once removed, clean the area before installing a new tip, if desired.


Will I need a dryer exhaust tube for a LG WM3431HS 2.4 cu.ft. Washer Dryer Combo?

no, this model does not require exhaust as it is a condensing dryer system


Pnp operating system eliminates the need to understand operating system hardware requirements and limitation before installing the system True or False?

False


Does a person installing a new computer sound system need any special knowledge about it?

If you're installing a new computer sound system, then you'll need some basic knowledge on the subject in order to succeed. It's important to make sure that the computer in question can support the new sound system.


Could you need to replace the entire Exhaust system to pass the emissions test?

If it is leaking or rotted