answersLogoWhite

0

yes, a standard tub requires 60 inches, I believe that it comes at 59.5 inches.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is the standard size for a tub rough opening?

The standard size for a tub rough opening is typically around 60 inches in length and 30 inches in width.


What are the standard dimensions for a rough opening for a tub installation?

The standard dimensions for a rough opening for a tub installation are typically around 60 inches in length and 30 inches in width. These dimensions may vary slightly depending on the specific type and size of the tub being installed.


What is the recommended rough in measurement for a tub spout installation?

The recommended rough in measurement for a tub spout installation is typically around 4 inches from the finished wall surface to the center of the pipe opening.


How high from tub to spout and mixing valve handle should you do rough ins?

I usually fit spout 6-8 inches above tub.


How large does a bathroom have to be for a tub?

Standard home tubs are 5 ft long. If the rough opening is 5 ft, you can slip in a tub. There are some mobile home tubs that are even smaller.ANS 2 - I've seen bathrooms as small as 7x7 feet with tub, toilet and sink/vanity.


How many gallons of water does a 84 inch by 84 inch hot tub hold?

30.55 gallons (rounded) for every inch the water in the tub is deep.


What is the standard depth for a tub drain rough in?

The standard depth for a tub drain rough in is typically around 1.5 to 2 inches below the finished floor level.


What are the tub rough in dimensions for the bathroom renovation project?

The tub rough-in dimensions for the bathroom renovation project are typically around 60 inches in length and 30 inches in width.


What if you get in the tub with eggs?

You can fit 400000009 eggs in a tub for a man who is 700 pounds.


I want to remove the tub and relocate the sink to where the tub was resuing the plumbing originally installed for the tub Can bathtub plumbing be reused for a sink?

yes you can, the pipes for the bathtub consist of your hot and cold pipes and a waste pipe. You may want to reduce the size of the waste down from inch and a half to inch and a quarter so it will fit onto the trap of the basin, this can be done with one cheap fitting called a reducer.


What is the recommended depth for a tub drain rough-in slab installation?

The recommended depth for a tub drain rough-in slab installation is typically around 1.5 to 2 inches below the finished floor level.


Will 20 inch rims fit a 1966 Nova?

I doubt it very much as there isn't much room on the rear wheel wells , it might be possible if you tub the rear wheel wells.