answersLogoWhite

0

There could be a few reasons why a 1997 Chrysler Sebring loses power and stalls at a low speed. The thermostat could be bad, the battery cables could be lose, or a spark plug may need changed.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

1997 sebring will start but stalls and if you try to use accelarator it skips and backfires also?

Replace the cam timing / speed sensor - about $75.


What forces ie speed would be involved when a vehicle stalls?

Loss of power, loss of forward momentum, loss of speed.


How to Set idle speed on a Chrysler sebring 1999?

Idle speed is not adjustable on this car.


How do you change the idle speed on a 2002 Chrysler Sebring?

Idle speed is computer controlled and is not adjustable.


2007 ford transit with a warning light on its a orange cog with an exclaimation mark in it anyone know what it means?

when driving it loses speed/power what causes this.


How do you adjust idle speed on 2010 sebring?

Idle speed is PCM controlled and is not adjustable.Idle speed is PCM controlled and is not adjustable.


What does a 1997 Chrysler sebring speed sensor look like?

Go to Kragen.com and search for speed sensor. You will find a picture of it.


Engine stalls or dies when stopping or turning?

The idle speed needs adjusted upward if an engine stalls when you take your foot off the accelerator while stopping or turning.


How do you adjust the idle on a 2008 Chrysler Sebring?

Idle speed is computer controlled and is not adjustable.


Why 88 Toyota truck loses power going up hill?

I have an 88 EFI truck and it loses speed (not necessarily power) going up hills because it is a manual transmission and it is geared low... and also if you are in higher altitude. Mountains ect..the electronic fuel injection may need to be redone.


How do you adjust the idle speed on a 2006 Chrysler sebring?

Idle speed is computer controlled and is not adjustable.Idle speed is computer controlled and is not adjustable.


Where is the vss wire on a 2007 chrysler sebring?

There isn't a vehicle speed signal wire on a 2007 Sebring. The transmission computer uses its input and output sensors to factor vehicle speed. It then transmits that message over the communication wires of the vehicle.