All u need to do is take the two wires that come off the top of carbs and connect them into each other on each end . so the two that run to the carbs are connected to each other and the two that go back to the handlebars are connected to each other these two must b plugged in for the sled to run. however the tors light is an overide safety switch so if ur throttle ever sticks hangon lol
yes
To disconnect the tors (Torque Over Rev Control) on a Yamaha Vector snowmobile, you will need to locate the tors unit near the throttle body. Remove the tors unit and disconnect the wiring harness connected to it. Please note that tampering with the tors system may affect the performance and safety of the snowmobile.
On the 1999 Yamaha SX500 Vmax snowmobile, grease nipples are typically located on the suspension components, such as the rear suspension and ski spindles. You can find them on the pivot points of the rear suspension arms and near the steering components. It's important to regularly grease these points to maintain proper function and extend the life of the snowmobile's suspension system. Always refer to the owner's manual for specific locations and maintenance guidelines.
how do you bypass passlock system
To bypass a water softener system, you can locate the bypass valve on the system and turn it to the "bypass" position. This allows water to flow through the system without being softened.
How do you bypass the alarm system on a 1990 Dodge Dynasty?
How do you bypass antitheft system on 98 ford mustang
How to bypass security system on 1990 Chevy camaro
Only authorized users can bypass the alarm system, call ADT for help with your system
where is the wire for theft system 2000 ford ranger to bypass
Hi, The short answer is: You don't. The explanation for that short answer is that you have to get the factory security system REPAIRED and working properly, as it is highly integrated into the ignition and fuel control systems of these vehicles. Sorry about that.
how to bypass vats on 95 camaro