NO
Belt , Traction drive P/N 53790 and Bel t, Auger drive P/N 3526.
Oscar Wilson.com bought all the parts for the Murray snowblower. Contact them and give them your model number and serial number of your snowblower and if they have any left they will take care of you.
A Roper 08 26 snowblower typically has two main belts: the drive belt and the auger belt. The drive belt connects the engine to the wheels, allowing the snowblower to move, while the auger belt connects the engine to the auger, enabling it to scoop and throw snow. If you're looking for specific part numbers or replacements, it's best to consult the owner's manual or contact a Roper dealer for accurate information.
You'll need the snowblower, the mule drive for the snowblower, and the belt off of your mower deck. The blower attaches where the mower deck mule drive snaps in with the two spring pins. The mule attaches to the bottom of the blower and back to the deck height adjustment hookup. Run the belt from your PTO, through your idler pulleys on the mule, then round the drive puller on the blower. Tension the belt and you're off. Case tractors are beautifully simple.
forward drive belt is a Gates # 6838 38x1/2 reverse belt is a Gates # 45x1/2
It depends on the snowblower, belt type and what you arer trying to achieve by making the change. The replacement pulley(s) will have to be the same shaft id as the original to start. Next make sure that there is room inside the snowblower for the new pulley. Thirdly the belt may have to change depending on the pulley size that you choose. There are many different pulley types and sizes available. Be aware of the changes that are made because they can decrease the snow throwing ability and also affect the drive speed and vice versa.
May possibly be a loose missing or worn belt.
I have a toro ccr 1000 snowblower. I need to know the lengh of the drive belt. the belt no. is 71-5381 I've tries a 34'' and a 35" belt. Can you tell me the lengh I need.
26"
Got a toro 521 wont blow snow after 2 feet whats up
To adjust the auger belt on a Sears model C950 snowblower, first, ensure the machine is off and disconnected from power. Locate the auger belt cover, usually found on the front of the snowblower, and remove it to access the belt. Adjust the tension by loosening the mounting bolts on the engine or idler pulley, repositioning the belt for proper tension, and then retightening the bolts. Finally, replace the cover and ensure everything is securely fastened before testing the snowblower.
Tighten it or replace it.