A STIHL 045 av is 75cc and the max recommended bar size for it is 32".
However... If you have a 045 av Super then it would be 87cc and the max recommended bar length would be 36". So it depends if you have a SUPER or not. It is easy to tell as it will say SUPER on the top tag right below 045 av.
The Stihl 011 chainsaw is typically compatible with guide bars ranging from 12 to 16 inches in length. However, it's essential to check the specific model and user manual, as compatibility may vary slightly. When selecting a bar, ensure that it matches the chainsaw's specifications and the type of cutting you plan to do.
Can I put a 18inch bar on a stihl
No, you cannot put a larger bar on a chainsaw for increased cutting capacity as it may affect the balance and performance of the chainsaw. It is recommended to use the appropriate size bar for the chainsaw model.
No, you cannot put a longer bar on a chainsaw for increased cutting capacity as it may affect the balance and performance of the chainsaw.
No, it is not recommended to put a larger bar on your chainsaw for increased cutting capacity as it can affect the balance and performance of the chainsaw, potentially leading to safety hazards. It is best to use the recommended bar size for your chainsaw model.
No, it is not recommended to put a longer bar on your chainsaw as it can affect the balance and performance of the tool, potentially leading to safety hazards and damage to the chainsaw. It is best to use the recommended bar length for your specific chainsaw model.
yes
Probably because it's just a safety feature that Stihl has put in so that if you pick it up wrong you don't hurt or maim yourself by accident.
First remove the clutch cover to expose the clutch, bar studs and area of the tensioner. Next you need to remove the bar studs. To do this tighten two nuts agains each other on the bar stud, then put a wrench on the lower nut and use it to loosen the whole stud. Repeat for the 2nd bar stud. Sometimes if you are lucky you can use vice grips on the shoulder of the stud to unscrew them, be careful not to damage the threads. After removing the bar studs, the inner bar plate and tensioner assembly lift right out. http://store.chainsawr.com/
You can use the same flywheel but need to put in a complete solid state ignition set up. http://store.chainsawr.com/
To properly put on a chainsaw chain, first ensure the chain brake is engaged. Then, loosen the chain tensioner and place the chain around the guide bar, making sure the teeth are facing forward. Adjust the tension so the chain is snug but can still be pulled easily by hand. Finally, tighten the chain tensioner and test the chain's movement before using the chainsaw.
To put a chain on a chainsaw, first make sure the saw is turned off and the chain brake is engaged. Then, loosen the chain tensioning screw and place the chain over the guide bar, ensuring it is facing the correct direction. Adjust the tension of the chain by tightening the tensioning screw until the chain is snug on the guide bar. Finally, release the chain brake and test the chain's tension by pulling it lightly.