you can eliminate your oil injection and premix your fuel. Good mixing Ratio would be 50:1 to start but you may go to 40:1 mixing ratio. Watch your plugs and make sure you're not too rich or lean to help you figure out what ratio to use.
It is oil injected, take the seat off and the tank will be located underneath. If the injection system is messed up, you can mix the gas to 32:1 and pour directly into the tank
Check your gearbox level you have an oil leak in your oil injection system or your gear box. The injection oil is lighter than the the gear box.
diagram oil injection system xlt 1200
IOR: is any method of producing or injecting (developing) a well (reservoir) that is not on primary production or commingled (not selective) production such as (secondary recovery like water flooding and tertiary like gas injection, chemical injection or microbial injection. EOR: its tertiary recovery techniques for increasing the amount of crude oil that can be extracted from an oil field either by using Gas injection, Chemical injection, Microbial injection or Thermal methods.
Use of a synthetic oil for the Suzuki DT50 outboard engine oil injection tank is recommended. A high quality 2T oil will provide maximum protection.
If operating the engine without the oil injection system, supplied with the engine, use a 50:1 ratio. When using the oil injection system, no additional oil is required.
This is a small two-stroke scooter with oil injection. It uses a two-stroke oil and you can buy this from your nearest Honda motorcycle dealership, or use any other acknowledged two-stroke oil.
yes for a 2 stroke engine.
generally if it has a separate resvoir you wont need to mix it just simplyuse good grade of 2 cycle oil
Yes it can, but only in pre-mix 2 cycle engines. These are the ones that you add the oil to the fuel. If the engine is an oil injection model, there is an opti2 Injection oil available.
the only oil in it is in the oil injection.If you dont use the injection the premix your fuel to oil
Three common methods to extract oil from the earth are drilling wells, using hydraulic fracturing (fracking), and employing enhanced oil recovery techniques such as steam injection or chemical injection.