answersLogoWhite

0

No 4 cycle motors have oil reservoir an 2 cycle motors you mix your with the gas (unless the 2 cycle motor is injected then you would put oil in a tank.)

Hope this helps

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What type of oil is in a oil gas mixture for a weed eater?

Two-cycle oil made for an air cooled engine.


How easy is it to replace a spark plug wire on gas weed eater?

How easy is it to replace a spark plug wire on a gas weed eater?


What gas oil ratio does a weed eater lt 7000 require?

What type of oil does weed eater or7000


What are some gas mixtures?

oil to gas ratio for weed eater


Is there a gas and oil mixture for the weed eater featherlite fl20?

The mixture is a 40:1 ratio, that's 3.2 oz of two cycle oil to 1 gallon of gas


What is the fuel ratio mixture for a Homelite st 275 weed eater?

50 to 1. 1 gallon of gas to 2.6 oz of 2-cycle engine oil.


Will weed eater gas in a car engine hurt it?

If, like most weed eaters, it is powered by a 2-cycle engine that has oil mixed with the gas, yes, it will be harmful to the car. If nothing else, the oil will foul the spark plugs and damage the catalytic converter.


What is gas ratio for Weed Eater Model 1700?

The gas ratio for the Weed Eater Model 1700 typically requires a 50:1 mixture of gas to oil. This means you should mix 2.6 ounces of 2-cycle oil with 1 gallon of unleaded gasoline. Always check the user manual for specific instructions, as ratios can vary by model or based on manufacturer recommendations.


How do you stop your ryobi weed eater from leaking gas out of the top when in use?

get a stihl


How much gas can a weed eater hold?

they can hold up to about 6 galons


What is the correct oil gas ratio for a shindaiwa weed eater?

Look in the operator/owners manual for the exact measurements for your weed eater. Pretty much everything is a 50:1 gas to oil ratio that I have ever used


How do you remove gas tank from craftsman weed eater?

To remove the gas tank from a Craftsman weed eater, first ensure the engine is cool and the fuel is emptied. Use a screwdriver to remove the screws securing the gas tank to the body of the weed eater. Carefully disconnect any fuel lines attached to the tank, taking note of their positions for reassembly. Once disconnected, you can lift the gas tank away from the unit.