Connect the + (Red) first
To safely disconnect a car battery, follow these steps: Tools Required:
Gas in the tank? Voltage Regulator output is: ? Was the proper polarity observed when reconnecting the battery ... red to positive, black to negative. Bad starter motor - Any spark at the plugs?
To change the battery in a Citroën C5, first ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery, then disconnect the negative terminal (black) followed by the positive terminal (red). Remove any securing brackets and take out the old battery. Place the new battery in, reconnect the positive terminal first, then the negative, and ensure everything is secured before closing the hood.
Airbag Control Module or (ACM) is located in the front of the center consol under all the black wires. Airbag wires will always be yellow before you mess with any wiring disconnect the battery and reconnect when finished.
When charging a battery, you should always connect the red cable first before the black cable.
To change the battery in a Nissan 350Z, first, ensure the car is turned off and parked on a flat surface. Open the hood, then use a wrench to disconnect the negative battery terminal (black) followed by the positive terminal (red). Remove any brackets or covers holding the battery in place, lift out the old battery, and place the new one in the same position. Finally, reconnect the positive terminal first, then the negative, and ensure everything is secure before closing the hood.
To change the battery in a Honda Ridgeline, first, ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the battery; disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove any brackets or covers, then carefully lift out the old battery and replace it with a new one. Reconnect the positive terminal first, then the negative terminal, and ensure everything is secure before closing the hood.
To change the battery on a 2007 Suzuki XL7, first, ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery; use a wrench to disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove any securing brackets or covers, lift out the old battery, and place the new battery in the tray. Reconnect the positive terminal first, then the negative terminal, and ensure everything is secure before closing the hood.
To wire a Mercury 881170A15 side mount control, first ensure the battery is disconnected. Connect the power wires from the control to the boat's battery, matching colors (typically red for positive and black for negative). Then, connect the throttle and shift cables according to the manufacturer's instructions, ensuring they are secure and properly adjusted. Finally, reconnect the battery and test the control for proper function before use.
Timing is 0 degrees. To do this you must disconnect the single wire connector near this distributor. It is a TAN with a BLACK stripe. Start Engine, the check engine light will be on this is OK you will clear it in the next step. Set TIMING to 0 degrees. Then turn off ignition and disconnect the battery for 1 minute this will clear the check engine light. Reconnect the TAN with Black Stripe wire connector. now reconnect the battery. Start your engine. That's it your done.
Lift the hood. Between the windshied wipers is a hidden panel with battery markings on it. Remove the panel. Disconnect the battery leads, I prefer to remove the ground (black) first then the red second. Check to see if there is a battery retention bolt or strap holding down the battery and remove it if its there. Take out the battery and drop in the new one making sure to reconnect all cables and any battery tie-down stuff.
To replace the battery in a 2005 Nissan Micra, first, ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery; disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove any securing brackets or clamps, then lift out the old battery and place the new one in the same position. Reconnect the terminals, starting with the positive terminal first, followed by the negative, and ensure everything is secure before closing the hood.