Yes.
The Honda CB125 was a motorcycle made by Honda. The motorcycle was manufactured from 1971 to 1975. It had an overhead camshaft engine, and could maintain speeds of 89km/h.
value of 1975 3 wheel honda
the first xr75 was built in 1973. i believe your is a 1975.
To install a 700R4 transmission in a 1975 350 Chevy engine, you'll need an adapter plate to connect the transmission to the engine's bell housing. You'll also need to modify or replace the driveshaft and ensure the transmission mount aligns properly. Additionally, consider upgrading the cooler lines and ensuring the correct linkage for the throttle and kickdown cable, as the 700R4 requires a different setup compared to the stock transmission. Lastly, make sure to connect the necessary wiring for the overdrive function and any electronic components.
Yes, the mounting position is the same, but the actual mounts are different. Bolt the mounts from your 1975 corvette to your 1996 LT1 engine and it should go right in. The transmission should also bolt right up to your 1996 LT1 engine.
I bought mine 4,000 € , with a 250ci six engine , automatic transmission , good shape .
650cc. Recommended volume is stamped into the side of the engine case above the kick starter.
It is possible, but there are so many parts that would have to be fabricated that is it likely more trouble than it is worth. The engine mounts, transmission mounts, drive shaft, shifter linkage and throttle linkage, would all be incompatible
The first Honda 1000 Goldwing was released in 1975.
13,000
Kiel Transmission Tower was created in 1975.
Well, honey, in a 1975 Cadillac El Dorado, the transmission dipstick is typically located towards the back of the engine bay, near the firewall. It's usually brightly colored for easy identification, so just look for a standout handle among all that vintage engine clutter. And remember, checking the transmission fluid is important, but don't go yanking on that dipstick like you're starting a lawnmower.