answersLogoWhite

0

What else can I help you with?

Related Questions

Could you please tell me the torque setting for Suzuki gsxr750 k7 oil drain bolt?

16.5 ft lbs. Suzuki Oil drain bolt


Where is drain plug on 49cc scooter?

The drain plug on a 49cc scooter is typically located at the bottom of the engine or the oil reservoir. It may be a bolt or a screw that can be removed to allow old oil to drain out during maintenance. Always refer to the specific owner's manual for your scooter model for precise locations and instructions.


How do you change the oil in a2001 suzuki katana 600 cc?

remove the oil filter. let it drain .Then remove the oil drain bolt at the bottom of oil pan and drain it. Put a new filter on and tighten it. Then tighten the drain bolt and fill to level with new oil.


How do you bolt your scooter?

you take a bolt and bolt it.


How do you check oil level in gearbox on a 2004 suzuki rm 250?

there will be a bolt on the right side by the water pump. take that bolt out and drain then fill it up till oil comes out the bolt..


How do you change oil on a 1988 suzuki 750 intruder?

Start bike and allow it to warm up. There is a large drain bolt beneath the engine crankcase. Remove the drain bolt and the oil will evacuate the crankcases. Reinstall the drain bolt. Remove the oil filter located on the front of the engine cases. Install a new filter. Bike will hold 3 quarts when changed with the filter.


Where is the drain plug located on the 2001 suzuki savage?

On the 2001 Suzuki Savage, the drain plug is located on the bottom of the engine, near the center. It is typically a hex-shaped bolt that can be accessed from the underside of the bike. To drain the oil, you'll need to remove this plug and allow the oil to flow out into a suitable container. Always ensure to replace the plug securely after draining.


What is Head bolt torque 2.0 suzuki forenza?

What is head bolt torque for 2004 Suzuki forenza 2.0


Can you put pegs on a scooter?

yes, you need to find a bolt that is quite long and stick it through the holes on the scooter so that about 5 inches of it is sticking out on the side you want the peg to be on, slide skateboard bearings on the bolt and screw a bolt on the end, there you go, a scooter peg.


How do you change oil on a Suzuki JR 80 dirt bike?

if you are trying to change the transmission oil, remove the drain bolt on the bottom of the motor. The drain bolt will have a sealing washer with it. Drain the old oil, install the drain bolt with washer (good idea to install new sealing washer) and tighten it. Remove the oil fill plug (on top of the right-hand engine cover), and put in the correct amount of oil (call dealer for type and quantity of trans. oil).


What are the head bolt torque specs for Suzuki a quadrunner?

Head Bolt Torque Specs for1995 Suzuki Savage Ls650ps


How do you check and where to refill transmission fluid for 86 suzuki samurai four wheel drive?

if you can see the drain bolt on the bottom of trans, the check or add bolt is vertical about 3 inches up on the right side of the trans housing