You simply get a screwdriver and loosen the upper and lower hose clamps and then remove the hose. New hoses can be a bit stiff when attaching them, be sure to renew the hose clamps as they are cheap and you can easily buy them in general automotive shops. Work on a cold engine and clean the places of attachment with fine grade sandpaper. Check for leaks and thighten hose clapms if necessary.
how do you put on the lower radiator hose on a 91 honda prelude?
Before replacing the radiator hose on a 1996 Honda Civic drain the coolant system. Once drained remove any clamps holding the hose in place and pull the unit off. Replace with new hoses.
You don't fix it you replace it. Drain the radiator, replace the hose, and the thermostat, flush the system, install a 50/50 mixture of antifreeze and water, bleed the system.
No, you do not have to remove the engine to replace a radiator hose.No, you do not have to remove the engine to replace a radiator hose.
Drain the radiator and remove the hose and remove the clog. I suspect you have other problems if you think the hose is clogged. I would suspect the thermostat is stuck closed. Replace the thermostat and flush the system.
follow lower hose to rear of engine. rember to bleed. bleeder located on the upper radiator hose housing.
Drain the radiator. Remove the lower radiator hose from the motor. Unbolt the hose inlet, and remove the thermostat. Replace the thermostat and the inlet, the hose, and refill the radiator.
I just had a radiator put in my 2000 Honda accord Friday today the car over heated I had it towed back to the shop that did the work they charged me for a heater hose and the tow
drain the radiator down below the top hose and unhook the hose from the radiator and the engine and pull the hose off.
Drain the Mercury Tracer radiator into a pan. Loosen the clamps at the ends of the radiator hose. Wiggle the hose to free the ends. Slide the hose off and replace it. Tighten the clamps an refill the radiator. Dispose of the old antifreeze as it is toxic to animals.
The hose is soft and mushy inside. Replace the hose. Possible clogged radiator. Replace the hose first. You also might have a clogged radiator core. Have a reputable radiator shop check and flush your cooling system.
The starter on the 1989 Honda Prelude is located on the left side of the engine. It is under the radiator hose that is at the rear of the radiator.