answersLogoWhite

0

There is two adjustments in the cable. One up by the lever and if needed one on the right side of the motor. You want to take most of the freeplay out of the lever. But not all of it! You should leave a little freeplay in you lever and you should be all set.

Good luck!

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you adjust valves on 2003 Yamaha Warrior 350?

With the engine at TOP DEAD CENTER (TDC) Adjust the exhuast valve to .007 and the intake to .005.


What is the Rear tire size for 2003 Yamaha warrior?

22x10x9


Can you adjust the clutch pedal on a 2003 Jeep Wrangler?

No.The clutch is hydraulic and not adjustable.


How do you adjust the carburetor on a 2003 Yamaha YZ250F?

With a screw driver


How much horsepower does a stock 2003 Yamaha warrior 350 have?

89 gerbil power


How do you adjust clutch in mx3 2003?

The last year the mx-3 was mad was 1996.


How do you set the idle on a 2003 Yamaha Big Bear 400?

To set the idle, adjust the carburetor.


Why wont your 2003 Yamaha tt-r 225 clutch disengage?

If the clutch on your 2003 Yamaha TT-R 225 won't disengage, it could be due to several reasons. A common issue is low or contaminated clutch fluid, which can affect hydraulic operation. Additionally, worn clutch plates or springs might prevent proper disengagement. Lastly, check for any cable adjustments or binding that could be affecting the clutch lever's movement.


How do you adjust the air fuel mixture on a 2003 Yamaha YZ125?

torque specs air fuel mixture screw on a yz125 2003


Where is oil pump on 2003 Yamaha Blaster?

It is located on the right side of the engine and is the most forward part of the clutch cover


Is a 2003 Yamaha warrior 350 2 stroke or 4 stroke?

its a 4 stroke they have always been 4 strokes


How do you adjust clutch on 2003 GTI?

It's a hydraulic clutch so its self adjusting. If your having problems the clutch itself may be bad or your slave cylinder may be going bad.