0
What else can I help you with?
How do you adjust a clutch on a 1998 suzuki intruder?
The Suzuki Intruder has a hydraulic clutch and therefor there is no adjustment.... There is an adjustment on the clutch lever for the distance from the grip, that is all...
How do you adjust the idle on 1998 suzuki 1400 intruder?
To adjust the idle on a 1998 Suzuki 1400 Intruder, first, ensure the engine is warm. Locate the idle adjustment screw, typically found on the carburetors or throttle body. Turn the screw clockwise to increase idle speed and counterclockwise to decrease it, checking the RPMs until they stabilize at the desired level (usually around 1,100-1,200 RPM). Finally, ensure the adjustment is done while the bike is in neutral for accurate readings.
Why does my 1998 suzuki intruder 1400 start and run fine but stalls when put in gear?
The kick stand is down or the kick stand switch is stuck.
Is this a suzuki intruder vin JS1VX51L2W2100423?
Yes 1998 SUZUKI VS1400GLP
Does a 1998 suzuki intruder 1400 have a choke on it?
If you're talking about the motorcycle, yes; it's on the left side, just under the lower edge of the tank, between the two cylinders.
Where is the fuse box for a 1998 suzuki intruder vl 1500 lc?
where is the fuse box 1500 suzuki intruder lc 2001
How do you remove the battery from a 1998 suzuki intruder VS 1400?
on the bottom of the motorcycle a door open to drop the battery down. loosen the bolt on the side ...but be careful the battery will drop down .
1998 suzuki intruder 1400 New clutch master cylinder and slave cylinder system has been bled i pull clutch in put in gear and it dies what else is wrong?
First thing to check, is your kick stand down? The Intruder has a safety switch. Next try going to the link as this is a message board that was originally dedicated to the Intruder.
Where can you find an owners manual for a 1998 Suzuki VL 1500 Intruder?
Log on to the delphi forum for Suzuki 1500LC/C90 Owners and there is a free manual there.
Is a suzuki intruder 1500 caburated or fuel injected?
1998 to 2004 is carburators and 2005 up are fuel injected.
Where is the oil dipstick for a 1998 1500 vl suzuki intruder?
There is no dipstick. There is a sight glass on the lower right side of the engine.
How do you set timing on 1998 1500 intruder?
To set the timing on a 1998 Suzuki Intruder 1500, first ensure the engine is at operating temperature. Then, locate the timing mark on the flywheel and the corresponding mark on the engine case. Use a timing light connected to the number one cylinder spark plug wire, and adjust the ignition timing by rotating the ignition coil until the marks align. Always refer to the service manual for specific timing specifications and procedures.
