To adjust the idle on a Yamaha Vino 125, locate the idle speed adjustment screw, which is typically found on the carburetor. Start the engine and allow it to warm up, then use a screwdriver to turn the idle screw clockwise to increase the idle speed or counterclockwise to decrease it. Aim for an idle speed of around 1,200 to 1,500 RPM for optimal performance. Always ensure the scooter is on a level surface and the engine is running smoothly before making adjustments.
I got mine doing 60, but it's a 2009
valve settings on a 2008 yamaha ttr 125
adjustmen
It just pops a cracks
The engine ID number on a Yamaha Vino 125 is typically located on the engine casing, often near the base of the engine or on the left side. You may need to clean the area to see it clearly, as it can be covered in grime or dirt. It's usually stamped directly onto the metal of the engine. If you have difficulty finding it, consulting the owner's manual can provide specific guidance.
The engine number for a Yamaha Vino 125 is typically located on the engine casing, often near the front or on the right side of the engine. It may be stamped directly onto the metal or found on a small label. To locate it, you might need to remove any covers or panels that obstruct the view. Always refer to the owner's manual for the exact location specific to your model year.
there is a nob on the carb just play with it until you get it adjusted
The serial number of a Yamaha Vino 125 motor can usually be found on the frame or engine of the scooter. The exact location may vary, but some common places to look include the following: On the bottom of the engine casing, near the center or rear of the scooter On the steering head, near the front of the scooter On the rear swing arm, near the back of the scooter On a metal plate attached to the frame, near the center of the scooter
No. The Yamaha YBR 125 has a four-stroke engine.
How much oil does a 2001 Yamaha TTR 125 hold? How much oil does a 2001 Yamaha TTR 125 hold? How much oil does a 2001 Yamaha TTR 125 hold?
yamaha xt 125 doesn't have oil filter.
On a 1996 Suzuki RM 125, the idle screw is located on the carburetor, typically near the throttle linkage. It can usually be found on the side of the carburetor body, often marked with a "+" and "-" for adjustment. To adjust the idle speed, turn the screw clockwise to increase the idle and counterclockwise to decrease it. Be sure to make small adjustments and check the engine's response.