answersLogoWhite

0

The following procedure applies to all small engines

If the engine does not start:

(1) rotate the carburetor main jet needle valve clockwise (close) until it touches its stopping point - DO NOT FORCE OR GO BEYOND THE POINT OF TOUCHING as it may damage the tip.

(2) Rotate the needle valve counter-clockwise (open) 1-1/4 to 1-1/2 turns - this should be close enough to start the engine. Start the engine and let it warm up about five minutes.

(3) Rotate the needle valve clockwise (close) slowly until the engine starts to stall for lack of fuel, then rotate the needle valve counter-clockwise (open) slowly until the engine starts to stall from flooding (too much fuel).

(4) Set the needle valve to a midpoint between the two extremes for the best "purr" of the engine. If the engine "sputters" when a load is added, open the needle valve an extra 1/8 turn for a slightly richer mixture.

If the engine starts and you just want to adjust the carburetor, steps (1) and (2) are not necessary.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How to Adjust brakes on Yardman riding mower?

How to adjust brakes on a yardman lawn mower


Adjust timing on a riding lawn mower?

No


How do you adjust the mower height on a lawn mower?

To adjust the mower height on a lawn mower, locate the adjustment lever or knob near the wheels. Move the lever or turn the knob to raise or lower the cutting deck to the desired height.


How do you adjustment the drive on a dixon 3014 mower?

adjust dixon 3014 cone drive lawn mower


How do you adjust the height of a lawn mower?

To adjust the height of a lawn mower, locate the adjustment lever or knob near the wheels. Turn the lever or knob to raise or lower the cutting height according to your preference.


How do you adjust carbon 1996 Murray 12 hp riding lawn mower?

It is important to adjust the carb on your 1996 Murray 12 HP riding lawn mower from time to time. You need to start with a warm engine, and adjust the screws to make them tight.


How can I effectively mulch with a lawn mower?

To effectively mulch with a lawn mower, adjust the mower to a higher cutting height, mow when the grass is dry, and mow in a crisscross pattern to ensure even distribution of the mulched grass.


How do you adjust rocker arms on a lawn mower?

read the owners manual there all different


How do you set the height of a lawn mower?

To set the height of a lawn mower, adjust the cutting deck to the desired height using the height adjustment lever or knob located on the mower. This will determine how high or low the grass will be cut.


What is a gas lawn mower?

A gas lawn mower is a lawn mower which is powered by gasoline.


How do you perform the mower height adjustment on a lawn mower?

To adjust the height of a lawn mower, locate the adjustment lever or knob near the wheels. Move the lever or turn the knob to raise or lower the cutting deck to the desired height. Make sure to adjust all wheels evenly for an even cut.


How do I properly adjust the height of my lawn mower for optimal performance and cutting efficiency?

To properly adjust the height of your lawn mower for optimal performance and cutting efficiency, first consult your mower's manual for specific instructions. Generally, set the mower deck at a height that allows the grass to be cut to about 2-3 inches tall. Adjust the height evenly on all sides to ensure an even cut. Regularly check and adjust the height as needed based on the season and grass growth.