The screw on the upper side of the carb is the idle speed adjustment. The air to fuel or air screw is located lower on the bottom of the carb, right in front of the carb bowl.
Procedure: First, warm the engine by driving the ATV for ten minutes or more, or let it idle. It has to be done outside in the open air, doing this in a closed garage can lead to sudden death from carbon monoxide poisoning. First, locate the idle adjustment screw. With the engine running, give this a few turns until you know how to increase and decrease the engine speed. Now, listen to the engine and twist the idle adjustment screw slowly from right to left or counter-clockwise. The engine speed will begin to drop. Now go on to turn the screw counter-clockwise until you hear the engine begin to stall or miss. When this happens, you turn the screw back half a in the other direction or clockwise.
For the air screw, to get a richer mixture then tighten this screw. To lean it out, loosen it. Do this in small steps, then try revvying and driving the ATV between adjustments until you are satisfied with the way it runs. A very lean air mixture will make the ATV backfire on deceleration. If this happens, enrich the mixture a bit.
can we adjust the clutch on honda civic 1999
regular
Take the old spark plugs out and screw the new ones in
No bands, all clutches. There is nothing to adjust.
With a boxed end wrench or socket, never with an open end wrench.
The wiring harness from the 1999 stereo has a 21 prong plug and the 1995 has a 14 prong plug you can purshase a harness from Honda but it has to be hadrwired to the exsisting wiring but don't screw it up, go to Honda and get a wiring diagram for the both of them to match up the wiring you need to make it work.
Start at 1 1/2 turns from seat and then adjust for the best idle
on the parking brake theres a bolt on the inner side, screw it inwards until the adjusment is right
look to the front of the carbs from the right hand side you will see a yellow turn handle adjust it clockwise to increase anticlockwise to decrease
to adjust the clutch on suzuki king quad 1999 locate the oil filter on the right side of the bike look for three bolts with a bigger one in the middle of the threethe middle srew will open up a nut and a set screw in the middle loosen the the nut and turn the the adjustment screw while you are in first gear . hope this helps you
There are screws on the base of the wiper (beneath black caps) loosen them, reposition the wiper then tighten the screw.
theres a screw that's brass in color on the throttle body turn until u get the desired idle s]oeed