To change the pick-up coil on a KX80, first, remove the stator cover by unscrewing the bolts and carefully taking off the cover. Disconnect the old pick-up coil from the wiring harness and remove it from the stator plate. Install the new pick-up coil by securing it in place and reconnecting the wires. Finally, reassemble the stator cover and ensure everything is tightened properly before testing the bike.
how to changr pick up coil 88 vandura
Usually, NO.
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
you must remove the distributor, disassemble unit and replace pick up coil
Remove Distributor,remove drive gear,remove shaft,remove pickup coil.
ITS the PICK-up COIL !!!!!!! to be safe just change the distibutor
To change the pick-up coil on a 1997 Mazda MPV, first disconnect the negative battery terminal and remove the distributor cap to access the ignition components. Carefully remove the rotor and the retaining screws to take out the pick-up coil. Disconnect the wiring harness and replace the old coil with the new one, ensuring proper alignment before reassembling the distributor. Finally, reattach the rotor, distributor cap, and reconnect the battery terminal.
The pick up coil for this engine should be right underneath the rotor inside the distributor cap. Unscrew the two screws holding the cap on, remove the rotor below it, then you should be able to lift out the pick up coil. I don't recall anything additional used to attach it, just the distributor cap screws.
Ignition coils are generally external while pick up coils are generally internal to distributor
Two Pick-Ups In One Did you know:A humbucking pick-up is a pick-up that has 2 single coil pick-ups put together.
Rotor Pick-up coil
In the distributor.