look at it,, figure it out
change the damm brake
The back brakes on my Honda Accord are disc brakes. After removing the brake cylinder assembly you will see the brake cylinder piston end has a slot in it. The short pin on the back side of the inner brake pad fits into this slot, but also it is used to 'Turn' (clock-wise) the piston back into the cylinder so you fit the assembly back over the new 'thicker' pads. You can not 'press' this piston back into the cylinder.
pull the plug off from the back of the ignition switch and then jump start it
what is the question about the back brakes?? they are usually drums
To change the back brake on the 2000 FXD kindly refer to your user manual.
To fill the brake fluid in a 2001 Honda Odyssey, you need to find the brake fluid reservoir and remove the cap. Fill the reservoir with the right amount of fluid and put the cap back on.
you open the truck or hatch and there should be a panel that comes off and u take it off and twist the light out change the bulb and place the light back in and put the panel back on the panel should be located on the inside of where the brake light is at
To shift the recon into reverse push the red button at the right break lever labeled "R" down and pull the lever back. Then shift down using the down arrow on the electric shift. Reverse light should come on and back you go.
How do you change rear brake drum on a 2004 Chevy Venture?
Over 20 mph, front brake then add back brake. Under 20mph a little front but mostly back brake. Under 5 mph back brake only. In an emergency front brake hard and add back brake hard. Change down after braking, even if you brake to a standstill.
I have an LX on mine all you do is on the back side of the caliber(the thing that holds your brake pads) on the bottom there is a bolt. Back out the bolt and rise the caliber all the way up and slide it toward the engine. That will take the caliber off and then you just replace the pads and do vise versa to put it back together.
Assuming you mean brake lights, the brake light switch is broken or out of adjustment.
remove the trunk lining or bend it back easy where the brake light is to access it and change it out.