To change the gear lube on a Yamaha 200E, start by locating the drain plug on the lower unit and removing it to let the old gear lube drain out completely. Once drained, replace the drain plug securely. Next, use a gear lube pump to fill the lower unit with fresh gear lube through the vent hole until it starts to seep out. Finally, replace the vent plug and ensure everything is tightened properly before testing the motor.
Synthetic lube
About 1 quart of gear lube
answered on dootalk. 75W90 synthetic gear lube
Because you have a seal that needs replaced. Some where on case causing it to leak gear lube.
The final drive on a 2008 Yamaha 650 typically requires about 180 milliliters (6.1 ounces) of gear lube. It's important to use the recommended type of lubricant specified in the owner's manual for optimal performance. Always check the level after filling to ensure it meets the manufacturer's specifications.
maybe
When you are looking for the object that is known as synthetic gear lube you can go to a store that is known as Wal-mart and buy gear lube for the car that you are driving.
8 ozs. i use 80-90w gear lube in my chaincase.
The price for Gear lube varies, depending on the brand and they type of lube you are looking for. On amazon. com you can get a 1.25oz tube of Oster Gear Lube Clipper Grease for under $5.00. You can also get a tube Sier Syntletic Gear Lube Volv0 can run you $185.00.
The recommended type of gear lube is a GL4 in a viscosity of 75W90.
Gear lube is thicker than both ATF and motor oil.Gear lube is thicker than both ATF and motor oil.
Does it have gear lube in the case? If so you will need to inspect clutch basket may need new clutch or clutch springs may have failed