Pull the primary cover. Bend the tab gently on the starter drive and loosen the tiny screw that holds the pinion gear on, then pull the wires off the starter and take out the two Allen bolts holding it in and the starter will come out.
What is it rubbing against? What size tire is on there? Is it the front or rear?
Remove the positive cable from your 2004 Pontiac Vibe battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Use Harley trans Fluid or Harley Formula +
Both sides or one side? If one side, which side?
when i change the starter corlla ce 2003 I take out a manifold
To change the starter in a 2004 Kia Rio, first disconnect the negative battery cable to ensure safety. Then, remove any components obstructing access to the starter, such as the air intake or engine cover. Next, unbolt the starter from its mounting, disconnect the electrical connections, and replace it with the new starter. Finally, reassemble everything in reverse order, reconnect the battery, and test the new starter.
possiblly the starter or fuel pump is out.
To change the starter on a 2004 Suzuki Forenza, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically positioned near the front of the engine. Remove the electrical connections and the mounting bolts securing the starter in place. Finally, install the new starter by reversing the removal process, ensuring all connections are secure before reconnecting the battery.
To change the starter on a 2004 Ford Escape, first disconnect the negative battery cable to ensure safety. Remove any covers or components blocking access to the starter, then unbolt the starter from its mounting bracket and disconnect the electrical connections. Install the new starter by reversing the removal process, ensuring all connections are secure, and reconnect the battery cable. Finally, test the starter to ensure proper operation.
To change the starter on a 2004 Kia Amanti, first, disconnect the negative battery cable to ensure safety. Then, remove any necessary components obstructing access to the starter, such as the intake manifold or engine cover. Unbolt the starter from its mounting, disconnect the electrical connections, and replace it with the new starter. Finally, reassemble any removed parts, reconnect the battery, and test the new starter to ensure proper functioning.
u dis conect ur battery first then u just take off the two wires going to the starter then the two bolts its just that simple
where is the starter located on a 2004 chevy suburban