answersLogoWhite

0

To change the engine oil in a Yamaha Bravo 250 snowmobile, start by warming up the engine for a few minutes to thin the oil for easier drainage. Once warmed, turn off the engine and remove the oil drain plug, allowing the old oil to fully drain into a suitable container. Replace the drain plug, then refill the engine with new oil through the oil fill cap, using the recommended oil type and capacity as specified in the owner's manual. Finally, check the oil level with the dipstick and dispose of the old oil properly.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

What is the best snow sled for an adult?

Type your answer here... In my opinion go with a Yamaha


What is the weight of a Yamaha bravo 250 snowmobile?

DIMENSIONSLENGTH115.9"HEIGHT44.1"WIDTH37.4"WEIGHT406 lbs.2010 YamahaBravo LTIn the early 80's the short track was available and had a weight of 386 lbs then the sled was only available in the long track at 406 lbs


How do you change oil and filter in 2003 Yamaha RX1?

There is a panel on the bottom of the sled. Unscrew the 5 screws with a allen bit. drain the oil from the plug that is there. You also have to take the right panel off the front of the sled and drain the oil out of the oil resevior. To change the oil filter, you have to remove the airbox, then the battery, then the battery frame. The oil filter is under all that. Hope this helps.


Why does my Snowmobile engine low speed cutout troubleshoot?

What type sled?


Is there a night of the living sled 4 on club penguin?

No, Night of the Living Sled was the last one. Night of the Living Sled was released 2009. There was no change in the 2010 Halloween Party on Club Penguin.


What oil gas mixture for 1979 srx Yamaha snowmobile?

The gas oil mixture for that sled is 24:1 according to the tag on my 79 srx.


How fast is the 1997 Yamaha Vmax 700 SX?

On snow, the sled will easily hit 100 mph in pure factory form but on ice it will get up to 125+ mph


How do you enhance the performance in a 1991 S10 with a 25l engine?

Not much; they are a sled. Sorry, but I had one. Mark


How much work must be done on a 5g sled to increase its speed from 10 ms to 15 ms?

The work done on the sled can be calculated using the work-energy principle. The change in kinetic energy of the sled is equal to the work done. Therefore, the work done on the sled would be the change in kinetic energy, which is calculated as (1/2) * m * (vf^2 - vi^2), where m is the mass of the sled (5g = 0.005 kg), vf is the final velocity (15 m/s), and vi is the initial velocity (10 m/s).


How would the acceleration of the right sled change up if the force were larger?

If the force on the right sled were larger, its acceleration would increase. This is because acceleration is directly proportional to force according to Newton's second law of motion. The larger force would result in a greater acceleration of the sled.


What type of sled is a luge?

a sled


Do sled dogs live in packs'?

They tend to live in there sled packs that they pull the sled in