0
What else can I help you with?
How do you replace the head gasket on a 1997 acura 3.2 tl?
how to change head gasket on 1997 acura
What is the gas mix ratio for a 1997 2 stroke Polaris scrambler 400 4x4?
For a 1997 Polaris Scrambler 400 4x4, the recommended gas-to-oil mix ratio is typically 40:1. This means you should mix 3.2 ounces of 2-stroke oil per gallon of gasoline. Always use high-quality 2-stroke oil and ensure thorough mixing to keep the engine running smoothly.
How do you change head gasket on 1997 Honda cbr 600f3 motorcycle?
To change the head gasket on the 1997 Honda CBR 600F3 motorcycle you will need the service manual.
Where is drain plug for crankcase for a 97 polaris scrambler 400?
The drain plug for the crankcase on a 1997 Polaris Scrambler 400 is typically located on the bottom of the engine case. You may need to remove the skid plate for better access. Look for a hex or bolt-type plug, which is often positioned towards the rear of the engine. Always ensure to have a drain pan ready to catch the oil when you remove the plug.
Why oil comes out spark plug on 1997 polaris sportsman?
if its water cooled you have water in the oil ie; head gasket or liner leaking.
How to change the Valve cover gasket on a 1997 Saturn sl2?
With tools
How do you change the valve cover gasket on a 1997 Chevy Venture van?
With a wrench
How much does it cost too get your head gasket done on a 1997 1.8 vectra?
For a basic change of a failed head gasket,reckon on about
How do you change the head gasket in a 1997 Chevy Venture?
i would love the help please
When was Nexus Polaris created?
Nexus Polaris was created in 1997-08.
How do you change oil pan gasket 1997 Ford thunder bird?
to change the gaket youl have to drain all the oil out and change your oil fluid filter and gasket the gasket is the seal between your pan and car take pan off drain clean and put new gasket on pan and put it back on.
How change oil pan gasket on 1997 grand am gt?
The oil pan gasket on a 1997 Pontiac Grand Am GT is changed by draining the oil, removing the oil pan bolts, and removing the pan. The old gasket is scraped away, a new gasket is placed on the pan, and it is bolted into place.
