answersLogoWhite

0

Remove the spark plug wire on the right side of the motorcycle. It's at the top of the motor, at the front of the fuel tank. You will need a special spark plug socket to remove the spark plug. Wherever you get the new spark plug's, they can get you the correct wrench. Put a 3 inch extension on the socket, It should go all the way down to the spark plug, and have just enough room to get you're drive ratchet on it to remove the spark plug. When you have screwed the spark plug all the way loose, You will need to remove the ratchet to pull the extension out with the socket, and the spark plug in the end of the socket. There should just be enough room to remove it. I had to remove a breather hose at the bottom of the fuel tank to fully remove it. Put the new plug in, Make sure it is secured in the socked, Mine dropped, and when I retrieved It, It had messed up the gap setting. The other one is on the other side at the rear of the fuel tank. You will need to remove the two bolt's at the bottom of the tank, and pull up on the tank, and prop it up with a WD-40 can so you can get the proper clearance to remove the second one. I found it easier to remove than the other one. There was no hose to remove.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the spark plug gap for a 1500 cc 2004 Kawasaki Vulcan Classic?

The spark plug gap for a 2004 Kawasaki Vulcan Classic with a 1500 cc engine is typically set between 0.028 to 0.032 inches (0.7 to 0.8 mm). It's important to check the owner's manual or service manual for the specific gap recommended for your model, as it may vary slightly depending on factors like engine modifications or specific requirements. Always ensure that the spark plugs are properly gapped before installation for optimal engine performance.


How do you change spark plugs on a 2005 Kawasaki vulcan 2000 ltd?

I took the seats off. Loosened the boly at the back of the gas tank. Lifted the tank up and used a 5/8 socket with rachet extention. not sure if that is right, but it worked.


How do you change rear spark plugs on a Ford Taurus 3.0 vulcan engine?

With a socket set :)


How many oil plugs on a vulcan 1500?

The Kawasaki Vulcan 1500 typically has two oil plugs: one for draining the engine oil and another for the oil filter. The engine oil plug is located on the bottom of the engine, while the oil filter is usually mounted on the side. Always refer to the owner's manual for specific details and maintenance procedures.


What spark plug is used in a 1993 Kawasaki zx 7l?

Anyplace that sells spark plugs will have an application chart which will tell you what plugs will work in your Kawasaki.


How many spark plugs are on a Kawasaki ninja 500R?

It has 2 plugs NGK D9EA


How do you change spark plugs on 2007 kawasaki 900 classic?

In your tool kit you should have a rench that will fit on the plug. You pull off the spark plug wire and take out the spark plug. Make sure the gap is set right for the new plug and put in in. Do not over tighten.


Where is the spark plugs located on 2005 kawasaki zx9r?

Kawasaki stopped making the ZX9 in 2003. If it is any other year you have to take the gas tank off & the air box to access the plugs.


How many spark plugs on a kawasaki ninja 600 zxr?

2


Why does the engine oil always turn black on my Harley Davidson Ultra Classic?

You should change your plugs and use lucas oil....


95 1100 kawasaki gpz with no spark to any plugs. coil been change although i haver power to the coils?

Check your fuse, ign switch and kill switch.


What kind a spark plugs you need for a 1986 454 LTD kawasaki?

Ngk d9ea