You can check it either on the side stand or center - see the note from the repair manual
e Caution:
Never fill with engine oil above the MAX mark in the
oil level inspection glass.
• Wait at least 10 minutes after a test run before
checking the oil; place the motorcycle on its centre
stand and check the oil level, topping up if
necessary.
Upper ring marking ....................................... MAX
Lower ring marking ........................................ MIN
L Note:
The centre of the inspection glass corresponds to
the MAX fill level if the motorcycle is standing on its
side stand
For a 2002 BMW K1200LT, it's recommended to use synthetic motorcycle oil with a viscosity of 10W-40. Look for oils that meet the JASO MA or MA2 standards, which ensure compatibility with wet clutches. Always check the owner's manual for any specific manufacturer recommendations or requirements.
The gear oil capacity for the final drive of a BMW K1200LT is approximately 0.4 liters (or about 13.5 ounces). It's important to use the recommended oil type, typically a hypoid gear oil with a viscosity of 75W-90. Always refer to the owner's manual or service manual for the most accurate specifications and maintenance guidelines.
If your 330i is a 2006 model or newer, it does not have an oil dipstick. Otherwise, check the oil dipstick for oil level.
To check the oil level on a BMW Z4, first ensure the engine is off and parked on a level surface. Open the hood and locate the oil dipstick, which is usually marked with a bright handle. Pull out the dipstick, wipe it clean with a cloth, reinsert it fully, and then remove it again to check the oil level against the marked indicators. If the oil level is low, add the appropriate oil type as specified in your owner's manual.
With the bike on its centerstand, the gearbox oil level should be just at the bottom of the hole for the fill plug.
there is no dipstick you check the oil level in the dashboard. check the reference guide or the owners manual
check oil level if ok its the vctec system
To read the oil level on the dipstick of a BMW 740il, first ensure the engine is off and parked on a level surface. Pull out the dipstick, wipe it clean with a cloth, and then reinsert it fully back into the tube. Remove it again and check the oil level, which should be between the two markings on the dipstick. If the oil level is low, add the appropriate oil type as specified in the owner's manual.
To measure the oil level in a 1994 BMW 740iL, first ensure the vehicle is on a level surface and the engine is warmed up. Turn off the engine and wait a few minutes for the oil to settle, then pull out the dipstick, wipe it clean, and reinsert it fully before removing it again to check the oil level. The oil should be between the two marks on the dipstick; if it’s low, add the appropriate type of oil as specified in the owner’s manual. Always check the level regularly to maintain proper engine function.
To change the oil depends on the engine model. Check your engine model first in the registration and go to the technical information in your BMW z3 booklet. To compensate the leaks or oil consumption (oil burned in the engine) you have to check the level on the dipstick. The oil level in the engine (cold) should be between the two signs on the dipstick. Never over fill and use the same quality of oil.
There is no dipstick. Check your engine oil level using the built in iDrive system. It should be under the service settings. The only other way to check the oil level would be to drain it and measure it. Read your manual for more information.
poop