The dipstick is on the right side of the crankcase, as seen when sitting on the bike. The dipstick has a triangular plastic head below the top knob, with a flat section at the end. For the most accurate measurement, place the bike in upright position, don't let it rest on the side stand. Unscrew the dipstick and wipe all oil of it, especially make sure there is no oil trace on the flat section. Then, put it in again and screw tight. Unscrew and look at the flat section. If the oil does not reach that part of the dipstick, then you must add oil as soon as you can and don't start the engine until more oil is added. If the oil reaches to the middle of the flast section or above, then the engine oil level is correct.
3.3 quarts
Use SAE 10w40 Full synthetic or conventional oil.
Pull the dipstick out and check the oil level.
10W40 - Haynes Service Manual
there is a dipstick beside the kick starter.
Add 2 quarts of Honda 4stroke motor oil then check the level @ dipstick and adjust accordingly. Good luck & don't forget to change the oil filter.
No, this is impossible. You must switch off the engine and let the bike stand level for a few minutes before you check the oil level.
i called the local Honda dealer and found the plug to check the gear oil
Most motorcyles have a liguid clutch which means they run in motor oil so when you change your motor oil you are changing your (gearbox) transmission oil and to check your (gearbox) transmission oil level you check the motor oil level.
The factory specs for a 2004 Honda vtx 1300 list the oil capacity at 3.9 quarts. Check the oil level to keep from overfilling.
To check the oil on a 2002 Honda Rancher, first ensure the ATV is on level ground and the engine is off. Remove the dipstick from the oil fill cap, wipe it clean, then reinsert it without screwing it in to get an accurate reading. Pull the dipstick out again to check the oil level; it should be between the upper and lower marks. If the oil level is low, add the appropriate type of oil as specified in the owner's manual.
it should be between two holes like engine oil level