answersLogoWhite

0

get a can of Carb Clean and spray outside of carb first, then remove all jets,and the bowl and remove the float and needle and seat,and spray thru all ports.blow out with low pressure air hose and put back together,make sure the needle is free and goes up anmd down with the float before asembly.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Clean the carburetor on a 1985 Honda xr200r?

Cleaning the carburetor is pretty simple. While the car is on, spray carb cleaner into the carburetor and wipe it with a dry lint free rag. A person can also take the carburetor out of the vehicle and clean it bit by bit.?æ


How do you clean a carburetor on a Honda fourtrax 350 ATV?

you have to take out the carburetor and then clean it


Where is Timing mark on 1985 Honda xr200r?

in the motor


Top speed of a 1998 Honda xr200r?

5 mph.


How much horsepower does a 1982 Honda xr200r have?

about 12 hp


Will a 1982 Honda xr200r engine fit on a 2002 Honda xr200r frame?

Yes, a 1982 Honda XR200R engine can fit into a 2002 Honda XR200R frame, as both models share a similar engine architecture and mounting points. However, some modifications may be necessary due to potential differences in wiring, carburetion, and exhaust systems. It's advisable to verify compatibility of components and consult specific resources or forums for detailed guidance on the swap.


How do you set the timing chain on a 1988 Honda xr200r?

how do you adjust the timing on a 1988 honda xr200


How do you clean the carburetor on a 1986 Honda Prelude?

Make sure your computer has no viruses


What year and model is a Honda vin jh2me05025k100438?

That would be a 1985 xr200r.


What type of oil does a 1998 Honda xr200r take?

10w-40


How do you clean a carburetor on a 05 Honda rincon 650?

To clean the carburetor on a 2005 Honda Rincon 650, first ensure the engine is cool and disconnect the battery. Remove the carburetor from the engine by detaching the air intake and fuel lines. Disassemble the carburetor carefully, then soak the parts in a carburetor cleaner solution, using brushes to clean out jets and passages. Rinse the components, dry them thoroughly, and reassemble the carburetor before reinstalling it on the ATV.


How can I troubleshoot and clean the carburetor on my Honda pressure washer to improve its performance?

To troubleshoot and clean the carburetor on your Honda pressure washer, follow these steps: Turn off the pressure washer and let it cool down. Locate the carburetor, usually found near the engine. Remove the air filter and inspect it for dirt or damage. Use a carburetor cleaner to spray and clean the carburetor thoroughly. Check for any clogs or debris in the carburetor jets and clean them out. Reassemble the carburetor and air filter. Start the pressure washer and test its performance. Cleaning the carburetor can help improve the performance of your Honda pressure washer by ensuring proper fuel and air mixture for efficient operation.