There is a chromed TORX screw on the rear fender behind the queen seat squab, Lift top box lid for better access. Make sure top box fully to rear and when lifting seat, back first, make sure bracket doesn't scrape the box.
Under seat.
Pull the seat off and disconnect the negative cable first.
google can tell ya that
On a 1999 Harley Davidson Ultra Classic, the turn signal module is typically located under the seat, mounted on the motorcycle's frame. To access it, you'll need to remove the seat by unscrewing the fasteners. Once the seat is off, you should see the module connected to the wiring harness. If you're having trouble locating it, refer to the owner’s manual for detailed guidance.
Yes , the circuit breaker is under the seat just in front of the battery.
A Harley Davidson Ultra can be purchased from a Harley Davidson dealership. On their website you can locate the nearest Harley Davidson dealership to you.
To remove the seat and fuel tank on a 2006 Harley-Davidson Ultra Classic, first, disconnect the negative battery cable to prevent electrical issues. Next, remove the seat by unscrewing the bolts or clips that secure it. After the seat is removed, locate the fuel tank mounting bolts and disconnect the fuel line and electrical connectors. Finally, lift the tank off carefully, ensuring no fuel spills.
yes
On a 1997 Harley-Davidson Electra Glide Ultra Classic, the fuse box is typically located under the seat. You can access it by removing the seat, which is secured by a couple of bolts or a latch. Once the seat is removed, the fuse box will be visible, allowing you to check or replace any blown fuses. Always refer to the owner's manual for specific instructions and fuse ratings.
On a Harley Ultra Classic, the turn signal module is typically located under the seat or in the fender area. Specifically, it can often be found in the rear fender or near the tail light assembly. To access it, you may need to remove the seat or certain paneling. Always refer to the service manual for your specific model year for detailed instructions.
Remove the Phillips screw or thumbscrew at the back of the seat, lift the rear of the seat slightly and pull it towards the rear tire. It should come right off.
Down the back of the queen seat there is a single screw into the fender. You might have to open the topbox for better access. Remove the screw, lift the rear of the seat ad slide backwards and upwards to release the front clip.