To release the seat on a Yamaha Road Star, locate the seat release mechanism, which is typically a bolt or a latch under the rear of the seat or near the rear fender. If it's a bolt, use the appropriate tool to unscrew it. If it's a latch, pull or push it to disengage the seat. Once released, lift the seat gently to remove it from the bike.
To remove the seat on a 2008 Yamaha Road Star, start by locating the seat release bolts or screws, typically found at the rear of the seat. Use an appropriate tool, such as a socket wrench or screwdriver, to loosen and remove these fasteners. Once the bolts are removed, gently lift the seat from the rear and slide it forward to detach it from the front clips. Store the bolts securely for reinstallation later.
To remove the seat on a 2003 Yamaha Road Star, locate the seat mounting bolts or screws, typically found at the rear of the seat. Use the appropriate tool, often a 5mm Allen wrench or a socket, to remove these fasteners. Once the bolts are removed, gently lift the rear of the seat and slide it forward to release it from the front mounting points. Make sure to keep the bolts in a safe place for reinstallation.
The 2006 Yamaha Road Star 1700 has a horsepower of 85 at 4500 rpms. The Yamaha Road Star can reach a total speed of 105 miles per hour.
To remove the back seat from a Yamaha V Star 950, first, locate the seat release mechanism, typically found under the rear of the seat. Use a wrench or socket to remove the bolts securing the seat if necessary. Lift the back seat upward and pull it off, ensuring any attached clips or fasteners are disconnected. Always refer to the owner's manual for specific instructions related to your model.
Approximately 68 horsepower.
The VIN number on a Yamaha Road Star is typically located on the right side of the steering head, which is where the frame meets the front fork. It can also be found on the frame under the seat or near the right side of the engine. It's important to check your owner's manual for the exact location, as it may vary slightly by model year.
To change the oil on the Yamaha 1600 Silver Edition Road Star, you would first need to remove the seat and the oil dipstick. Then, remove the oil drain plug on the engine. Allow the oil to drain and remove the filter. Add the new filter, fill the oil, and close all of the drains. You can see full details of the procedure with photos at Road Star Clinic online.
Stamped in the frame just below the seat.
Under the drivers seat
Yamaha Road Star 1700 (year: 2004). I do not know the way to properly set the height on my head light.
Type your answer here... Under the seat
XV1600A Road Star (1999-2005)XV1600ALE Road Star Limited edition (2003)XV1600AS Road Star Midnight Star (2001-2003)XV1600AS Road Star MM Limited edition (2000)XV1600AT Road Star Silverado (1999-2005)XV1600ATLE Road Star Silverado Limited edition (2003)