To lift the seat on a 1200cc Suzuki Bandit, locate the seat release mechanism, usually found under the rear of the seat or near the tail. Depending on the model year, you may need to turn a key in the lock or pull a lever. Once released, gently lift the rear of the seat to detach it from the mounting points. Ensure to secure it back properly after completing your task.
lift the seat. behind the locking mechanism you'll see two small black blocks. one of them says FUSE on it.
To remove the seat from a Suzuki Bandit motorcycle, start by locating and removing the screws or bolts securing the seat, typically found at the rear or under the seat. Once the fasteners are removed, gently lift the seat upward and back to release it from the mounting points. Ensure you check for any additional clips or connectors, especially if the bike has a seat lock mechanism. Always consult the owner’s manual for specific instructions related to your model.
under the seat on the left side, is a helmet lock. Place your key in the lock and turn it. That unlocks the seat. Then just pull back on the seat and it will come right off.
i own a 87 suzuki savage i would expect it is the same steps there is two screws that hold the seat on there located towards the rear of the drivers seat not the passengers seat after removeing the two screws the seat should lift free there is one screw under the drivers seat that holdes the passenger seat on remove that and push the passenger seat forward and lift
under the seat.
On the 96 to 03 Bandits you have to remove the seat (turn the helmet lock about a quarter turn in the opposite direction as when you open the hook, then lift the rear end of the seat). Just behind the fuel tank you'll see a plastic cover with two screws that has a battery outline. Remove the two screws and you'll find the battery inside.
On a 2005 Suzuki Bandit 1200, the 30 amp fuse for the ignition is typically located in the main fuse box, which is found under the seat or near the battery. To access it, remove the seat and look for the fuse box cover. Once opened, you should see the fuses, with the 30 amp ignition fuse clearly marked. Always consult the owner's manual for specific details and locations.
The back of the seat has a key hole. Insert ignition key, turn, lift and slide aft a bit. Seat will go back on with the key or without (just press down hard without key).
To remove the seat on a Suzuki S83 motorcycle, locate the seat release mechanism, which is typically a bolt or a latch under the rear of the seat. Use the appropriate tool, such as a wrench or screwdriver, to loosen or unscrew the fastener. Once released, gently lift the seat from the rear and slide it forward to detach it completely from the mounting points. Ensure that you store any removed components safely for reinstallation.
If you lift up the seat there will be a flat metal bar behind the storage space. the numbers might be a little rusted over but it will be there :)
The battery is under the back seat, at the front of the seat are two clips lift these and the whole back seat will lift out and you will find the battery there. The battery is under the back seat, at the front of the seat are two clips lift these and the whole back seat will lift out and you will find the battery there. The battery is under the back seat, at the front of the seat are two clips lift these and the whole back seat will lift out and you will find the battery there.
To remove the seat on a Suzuki 50cc wheeler, start by locating the seat release mechanism, which is typically a bolt or latch under the seat or at the rear. Use a suitable tool, like a wrench or screwdriver, to loosen or unfasten it. Once the mechanism is released, gently lift the seat from the back and slide it forward to detach it completely. Be careful to avoid damaging any wiring or components connected to the seat.