To make the reverse lights work on a Polaris Sportsman, ensure that the reverse switch, typically located on the transmission or near the shifter, is functioning properly. Check the wiring for any damage or loose connections. Verify that the bulbs are intact and replace them if necessary. Finally, consult the owner's manual for specific troubleshooting steps related to your model.
yes ,i think they started in 94 and made them for a few years .
Most 91 polaris 400's are 2-stroke , and there is an oil tank in the front . Make sure the oil is 2-stroke oil for injection .
The oil fill on a Polaris Sportsman 500 is typically located on the right side of the engine, near the front. You'll find a dipstick or a fill cap that can be removed to add oil. Always make sure to check the owner's manual for the specific location and to verify the correct oil type and capacity for your model.
On a 2001 Polaris Sportsman 500 HO, the crankcase dipstick is located on the right side of the engine, near the rear. It is typically attached to the oil fill cap, which you can unscrew to check the oil level. Make sure the vehicle is on a level surface and the engine is cold for an accurate reading.
The oil capacity of a 2003 Polaris Sportsman 400 is approximately 2 quarts (or about 1.9 liters) when using a filter. It's important to refer to the owner's manual for specific recommendations and to ensure proper maintenance. Always check the oil level with the dipstick after adding oil to make sure it is at the correct level.
check fuses, check bulbs, from there see if there is a grond for your reverse lights that may need cleaning. If still no lights, make sure there is a good wire back to the transmission for your lights. Still no luck, look into the sensor on tranny for your reverse lights. Good luck.
presuming you've checked all the fuses and relays theres a sender switch on the transmission should have 2 wires attached to it.. make sure the wires are not disconnected or damaged
The most common reason for and electric fan not to run is a disconnected wire. Make sure all of the wires are connected and not corroded.
Air / petrol setting in the carberator requires setting. Also check the float level and needle height.
On a 2004 Polaris Sportsman 500 ATP HO, you should grease the front and rear suspension components, steering components, and drive shafts. Use a high-quality lithium grease and follow the recommended intervals in the owner's manual for regular maintenance. Make sure to clean and inspect the components before greasing to ensure proper lubrication.
check the reverse light switch and all connections
yes,mix it 32-1 or 40-1 ,make sure the oil is 2-stroke for injection or pre-mix