To remove the brake drum on a Honda Rancher 350, first ensure the vehicle is on a stable surface and the rear wheels are lifted. Remove the wheel by loosening the lug nuts and taking off the wheel. Next, locate the retaining bolts or clips securing the brake drum, remove them, and then gently pull the brake drum off the hub. If it’s stuck, you may need to tap it lightly with a rubber mallet to loosen it.
Hold down red button with R on left hand brake, pull the bake all the way back and down shift then release brake an button
Unlock and pull out from the exhaust
While stationary and in neautral there is a red button on the left handlebar on the rear brake lever. You need to push this down and pull the brake lever and then you can push the foot gear selector down for reverse.
To put a 2013 Honda Rancher TRX 420 in reverse, first ensure the vehicle is at a complete stop. Then, locate the reverse lever, typically found on the left handlebar. Pull the reverse lever while simultaneously pressing the throttle to engage reverse. Release the brake and gently accelerate to move backward.
You will have to get a brake spoon and from the backside of the drum pull out the rubber plugs and look inside and you will see a gear wheel, the wheel needs to be turned downward to back the brake shoes off from the drum and then the drum should come off.
pull the wheels off and on the studs there is two loskrings that hold the drum on during assembily.remove these and the drum should slide off. if not go to the back of the drum and at the lower part of the backing plate you will see a rubber gromet. pull it out and use a brake spoon to adjust the shoes enough to slide the drum off.
should just pull off if parking brake not engaged
Remove the wheel and simply pull it towards you while turning the drum. If that doesn't work, hit it with a hammer to break it free, then pull it off.
you must pull the axles, remove the bearings and then the hub/brake drum assmbly. comes off as one unit.
You have to disassemble the wheel bearing, then the drum and hub pull off as an assembly.
Jut pull of drum if not 4 wd, make sure parking brake off and you may have to tap it a couple times.