answersLogoWhite

0

To put a new keyway on a riding mower, first, ensure the mower is turned off and the spark plug is disconnected for safety. Remove the drive pulley or the part that houses the old keyway, and clean the area thoroughly. Insert the new keyway into the slot on the shaft, align it properly, and reassemble the components, making sure everything is secured. Finally, reconnect the spark plug and test the mower to ensure it operates smoothly.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where do you put the oil 317 john deere riding lawn mower?

where do you put the oil at for a john deere 317 riding lawn mower and what brand of oil


Recently just put in new battery and lawn mower wont turn over?

Perhaps it is the starter drive. That happened to my riding mower. Got the drive replaced, works fine.


How do I put on riding mower blades?

you get the mower and flip it n it's side then you unscrew the bolt. take off the old blade and pt the new one on then you screw the bolt back on.


What happens if i put too small of a Muffler on a riding lawn mower?

donno


Does anyone have a picture or diagram on how to put on a belt on a Murray riding mower?

According to Youtube


Why would a push mower not start?

No spark, no gas, timing off [sheared keyway] remove plug attach wire lay on motor crank it, do you have spark? put a small amount of gas into spark plug hole, replace plug, doe,s it start? misfires ? replace keyway , under flywheel, Where I come from a push mower does not have an engine so it starts when you do.


What to do if i put to much oil on my riding lawn mower?

Go to the drain plug and let some out


Why won't my riding lawn mower start i put new gas new oil brand new spark plugs but it still wont start?

replace battery & starter solenoid.. possibly carb.


Why does torro riding mower stall when put into gear?

This is usually caused by a faulty seat safety switch.


How do you change Friction drive on Ariens Riding Mower 927046-RM1028?

Stand the mower up on the end.there are four bolts that hold it on ,take them out and pull the old disk off and put on the new one,u can buy new disk at ace for $11.00 hope that helps


How do you change Friction drive on Ariens Riding Mower 927046 RM1028?

Stand the mower up on the end.there are four bolts that hold it on ,take them out and pull the old disk off and put on the new one,u can buy new disk at ace for $11.00 hope that helps


How do you put a go kart clutch on?

to put the clutch on omn side of the motor theres a crak and you to the clucth on there then put the keyway in the slot or you dont have to if the clucth has a biuld in keyway