VERYCAREFULLY!!
place the magnet on the flywheel in front of magneto and place a buisness card between flywheel and magneto and tighten magneto down.......remove buisness card..
3-arm puller
no.
take magneto off and use fine sandpaper or emory board and knock off surface rust on edge that contacts flywheel........when replacing turn flywheel to where magnet is in front of magneto and place buisness card between flywheel and magneto and tighten down ...remove buisness card......
top speed of a yz125 in mph
all yz125's are 2 strokes
Obviously yz125 is more faster than yz85.
a yz 125 goes 80mph
YZ125 is referring to a Yamaha motorcycle with a two stroke engine designed for motorcross riding. The Yamaha YZ125 weights 189 pounds dry and 208 pounds wet.
Remove all exposed bolts holding the magneto cover on. However Suzuki decided to hide one behind the Starter cover. So you need to remove the 3 Phillips screws holding that on. I had to use a #3 driver, tap on it with a hammer to seat it then, with some strength, turn them out. You will see that last screw inside. Wiggle it out. Things will start to drop like small cylinders. remember where they go for reassembly. Remove the magneto and other electrical mounts and replace in new cover. It is fragile so be careful taking it out.
magneto is dc
Cap'n Magneto was created in 1985.