To remove the oil tank from a Yamaha Razz, first ensure the engine is cool and disconnect the battery. Then, locate the oil lines connected to the tank and carefully detach them, using a container to catch any spilled oil. Next, unscrew any mounting bolts securing the oil tank in place, and finally, lift the tank out of its compartment. Make sure to follow proper safety precautions and dispose of any oil properly.
Try replacing your current 2 stroke oil with 100 percent synthetic 2 stroke oil. Available at any motorsports dealer. Worked for my Razz. Has not smoked since.
2 places
There are several reasons why a Yamaha Razz may quit running. These include issues with the engine, its age, issues with spark plugs, lack of gravity, lack of oil, lack of gas, etc.
under the rear fender on the left side.You must first remove seat so that you can access the cap for the oil tank.Do not remove foam baffle from oil tank.
For the Yamaha Razz, it's recommended to use a high-quality gear oil, typically a 75W-90 or 80W-90, depending on the climate and riding conditions. Always refer to the owner's manual for specific oil specifications and capacities to ensure optimal performance. It's important to use oils that meet the manufacturer's standards for best results.
there is no oil tank on a Vmax motorcycle. The only oil is in the crank case, and the shaft drive.
It holds 700 cc of 10w-30 motorcycle oil ( or .7 litres ). I know this because I just got done replacing my clutch and drive chain.
What is the gas to oil ratio fot a 1982 Yamaha PW50? Do you need to mix it manually or does it automatically mix together by putting straight gasoline in the gas tank and straight oil in the oil tank?
To check the oil level in the oil tank of a Yamaha PW80, first ensure the bike is on a level surface and the engine is cool. Locate the oil tank, which is typically on the right side of the bike, and look for the oil level window or dipstick. If it has a window, check that the oil is within the marked range; if it has a dipstick, remove it, wipe it clean, reinsert it without screwing it in, and then check the level. Add the appropriate 2-stroke oil if the level is low, ensuring to use the correct type recommended in the owner's manual.
no its premix but there is 4 stroke oil in the gear box
Under seat the back black tank is for gas. The white tank in the front of the black tank is the 2 cycle oil.
If its an oil injected motor there is a tank that holds the mixing oil if its just a straight carburated motor the oil mixes with the gas in a can then put it in the gas tank.