there are four screws on the coner of the cover just remove them and it comes offr
Follow the instruction in the link to remove the plastic cover http://www.installdr.com/InstallDocs/Honda/PDF/466053.pdf
Left side of the bike. Remove plastic cover just below seat.
To remove the drive shaft from a 2003 Honda Rincon ATV, first ensure the ATV is on a stable surface and disconnect the battery. Then, remove the rear wheels and the rear differential cover to access the drive shaft. Disconnect the U-joint bolts from both the front and rear, and carefully slide the drive shaft out of its housing. Finally, inspect the components for wear before reinstalling or replacing as necessary.
There is a plastic cover in front of the engine. Under the cover is the intake manifold. After you have removed the plastic cover, then the intake manifold you will see the starter. Before you can remove the starter you will need to remove wires tubes and linkages. It will take a few hours if you are good.
To set the timing on a 2003 Honda Rincon, first ensure the engine is off and cool. Remove the timing inspection cover to access the timing marks on the flywheel and the crankshaft. Align the timing marks according to the specifications in the owner's manual, ensuring the piston is at top dead center (TDC) on the compression stroke. Once aligned, replace the cover and recheck the timing as needed to ensure proper engine performance.
I'm not sure if this helps you but please check it out: http://www.installdr.com/InstallDocs/Honda/PDF/466053.pdf
The taillight bulbs can be easily replaced on a Honda Civic. Open the trunk and locate the plastic covers. Remove the plastic cover and pull the bulbs. Replace with new bulbs and install the covers.
Manual window cranks are held on with a screw on 1997 Honda Civics. Remove the plastic cover on the handle to reveal the screw. Loosen and remove the handle. Replace with a new unit.
There is one pictured in the owner's manual - if you don't have a manual, remove the cover on the fuse paenl and the positions of the fuses are embossed into the plastic on the back of the cover.
Owners manual. remove glove box, cut plastic brace if this is the first time, remove metal brace, remove filter cover and pull out filter
hello the fuse box is located on the right side below the side cover it has a rubber cover then a screw to remove the plastic cover the fuse should be the top fuse.