Its under the rider's seat. You have to remove th seat.
you must remove the bolt behind the rear seat and remove the rear seat then you will see 2 small Allen head bolts remove them and the seat will come right off.
The battery on a Suzuki Boulevard is located under the driver seat.
You need to remove the rear seat before you can removed the front. First removed the one screw on the back of the rear seat then removed the two screws on the front of the rear seat. You can not get to the front screws until you remove the rear screw.
The fuse box on a 2006 Suzuki Boulevard M50 is typically located under the seat. To access it, you'll need to remove the seat by loosening the bolts or fasteners. Once the seat is removed, the fuse box should be visible, allowing you to check or replace any blown fuses. Make sure to consult your owner's manual for specific details and diagrams.
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Remove side covers and then remove the two front seat bolts(10mm) the seat will slide forward slightly and lift off. Replace making sure the bottom rear tab on seat goes into its mount. Note the left side cover has a small Philips screw on the bottom which is awkward to get at.
The fuse box is located on the left side of the bike. you have to first remove the seat, then the black panel below it, then the chrome panel below that. there is a black box with "fuse" stamped on it.
You have to remove the Allen bolt on the rear of the passenger seat, then remove the two Allen bolts exposed when you removed the passenger seat. The driver seat should slide back and off now.
Yes, you just need to remove the center bracket (back seat bracket) on your bike
Use your key on the left side by the seat. turn it counterclockwise. and the front seat should pull off. Once you remove the front seat there are two releases to remove the rear seat.
You can remove the off a Suzuki 230 4 wheeler by locating the mounting bracket on the floor of the vehicle. Once you find that, you can remove the screws in the plate with a Phillips head screw driver, and take the seat out.