0
What else can I help you with?
Craftsman riding mower The oil dip stick is stuck I can turn it left and right but it won't come out?
Sometimes Evelyn's lawn mower does this too. I take a sledgehammer and break it.
How do you remove rear wheel on a snapper riding mower?
To remove the rear wheel from a Snapper riding mower, first ensure the mower is turned off and securely parked. Use a wrench to remove the bolt or nut securing the wheel to the axle. Once the fastener is removed, pull the wheel straight off the axle. If the wheel is stuck, gently tap it with a rubber mallet to loosen it before removal.
How do you fix a riding mower that has gas in the oil?
You probably have a stuck float or the carb is out of adjustment or choke is stuck on. hope this helps
What would cause a carburetor to over flow on a riding mower?
Stuck floats or dirty needle valve.
How do you remove a stuck oil cap on a lawn mower?
you give it a big hug
Why is your craftsman riding mower not moving?
1) The drive belt could be broken. 2) The rearend could be bad 3) The brake on the rearend could be stuck. (this would make the rear tires lock up) 4) The pulley on the engine or rearend could be the problem. You need to do a little investigating to see what is going on where.
One of my back tires on my riding lawn mower is locked up and wont movewhat's wrong?
Pins on the brake disk on transaxle are rusty and stuck.
Why Craftsman hydrostatic riding mower wheels locked while trying to load on trailer. Mower needs repair but when you push it the wheels just slide and none roll. There is a lever to lock on back and?
Chances are that it is the brake on the transaxle that is stuck. If you look under the mower from the rear, on the right side of the transaxle is the brake assembly. There is a long rod going to it. The arm is probably stuck in the applied position. You should be able to grab it and move it to release the brakes. If it has been parked a long time with the brake applied you might have to take this assembly apart and clean and lubricate the parts. It's not a tough job.
How do you remove a stuck gas cap on a lawn mower?
To remove a stuck gas cap on a lawn mower, first ensure the mower is turned off and has cooled down. Try twisting the cap counterclockwise while applying gentle pressure; if it's still stuck, use a rubber glove for better grip. If the cap remains stubborn, consider applying penetrating oil around the threads and letting it sit for a few minutes before attempting to twist it off again. If all else fails, a pair of pliers can be used carefully to grip and turn the cap, but be cautious not to damage the cap or the mower.
What is wrong with Craftsman riding mower that won't idle?
The governor is probably stuck. If you are not sure where the governor is located, follow the wire link from the carburetor throttle to the governor lever. The lever has very short back/forth movement, however it should travel freely. Clean off all debris and gunk from the area where the governor lever goes into the engine to see if that will loosen up the governor.
Which way do you turn the nut to take off the blade on a John Deere riding mower?
Counter-clockwise to remove (lefty loosy, righty tighty). The nut may be pretty much stuck due to dirt, debris, time, etc, but it takes a counter-clockwise roation fo removal.
Why does your mower whine when you try and start it?
The starter is stuck.
