The steel battery enclosure is just behind the engine and just in front of the rear tire. The battery is removed from the bottom of this "box" from a "trap" door which is hinged with two small bolts; one bolt on either side of the battery box. Both are lowest down and forward. This trap door hinges from the rear of the enclosure. I believe a 10mm wrench is required.
Before you remove the lower "hinge" bolts, be sure to first remove the plastic "dust" cover of this same battery box by removing two Phillips head screws. Then you can "wrestle" out the ridiculously snug battery box cover. With the cover out, you can then access and remove the two cable-terminal screws from either side of the battery to disconnect the cables. Now remove the two bottom bolts. You may have to smack the sides of the box a couple of times with a rubber mallet since it may be stuck closed with road grime; the battery will drop to the ground. There is just barely enough room to twist the battery away from under the bike if your working on the ground with kick stand.
its under the engine
four and one half quarts
1.8 qt no filter-------2.1 with filter
3 litres if you're not changing the filter , 3.5 litres if you are
I have a 2007 SUzuki Boulevard that has blown the main fuse twice. Each time I've taken it to the shop, they don't find anything. What year is your's? lukedavi@gmail.com
In a 2007 Boulevard S40 the positive terminal of a battery is located where the red terminal is. Another characteristic that separates it from the negative side is the width of the positive terminal.
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Reset tje battery
Very carefully
To change the battery on a 2007 Suzuki XL7, first, ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery; use a wrench to disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove any securing brackets or covers, lift out the old battery, and place the new battery in the tray. Reconnect the positive terminal first, then the negative terminal, and ensure everything is secure before closing the hood.
To remove the engine cover on a 2007 Suzuki XL7, first, ensure the engine is cool and disconnect the negative battery terminal for safety. Locate the bolts or screws securing the cover, typically found around the perimeter. Use a socket wrench or screwdriver to remove these fasteners, then gently lift the cover off the engine. Be cautious of any clips or connectors that may also be attached to the cover.
Boulevard and Ponce - 2007 was released on: USA: 31 January 2007