Generally a short length of 2x4 to wedge the blade and a 9/16" or 5/8" socket (whichever is appropriate) and ratchet will do the job.
turn the mower on its side with the oil stick on the top side of the motor on the bottom of the blade there should be a 3/4 bolt take it out the blade should slid right off the spindle make sure you put all washers and retaining nuts back exactly the way you found them.. it could hurt if you dont..
yes
you have to remove the flywheel with a flywheel puller or maybe knocking it off with small hammer blows.
Ranch King is merely a brand name...the maker....MTD Products, Cleveland, Ohio.
You can get an operating manual for a Club King garden tractor mower at various tractor supply retailers. You can also check with the manufacturer to get a manual.
Any good lawn mower repair shop should be able to order just about any brand of mower part for you. Good luck.
You buy King Alteon's blade from the Good Shop (not good rep shop.) It's for members only sadly.
MTD
If it is a multi blade unit check to see if the blades are the correct size, otherwise when mulching the machine is cutting and recutting the grass inside the deck, the grass must be cut often and it must be dry. Either of these conditions will cause too much grass to be inside the deck slowing down the mower and lessening its ability to cut. Traction speed must be also slow. You can probably hear rumbling noises in the deck along with the engine slowing down and when you lift the deck up wet grass will spit out. As a trade for not bagging clippings you will need to slow way down, cut often enough that you are cutting less each time, never cut when the grass is wet. The first thing i would do is to confirm proper/correct blade installation. If the blade is upside down it will cutwith the back side of the blade (not sharp). With the blade in place and the spark plug disconnected, gentle pull the starter handle with only enough force to cause the blade to turn slightly. Is the blade's sharp edge the leading edge. If not then remove turn the blade over and try it again. I have done this my self when i was in a hurry hope it helps.
Blade of the King Concept Film - 2005 was released on: USA: 9 December 2005 (Austin, Texas)
.030
King Camp gillette King Camp gillette King Camp gillette