The 2002 Harley-Davidson motorcycle transmission drain plug can be removed with a 9/16 socket. A five-point socket will work the best
remove seat, remove neg cable from frame and Pos from battery, remove strap and take out battery.
you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.
The 2003 Harley-Davidson Heritage Softtail transmission drain plug is on the bottom of the transmission. The drain plug is flush with the bottom of the transmission. You can remove it with a half inch ratchet.
Remove the rear seat screw. Then pull the rear seat to the rear and slightly up. It is held in by two metal tabs that slip under the front seat lip.
To fill the transmission oil on a 2004 Harley-Davidson Fat Boy, first ensure the motorcycle is on a level surface and the engine is warm. Remove the transmission filler plug, typically located on the side of the transmission, and use a funnel to pour in the recommended transmission oil until it reaches the bottom of the filler hole. Replace the filler plug securely. Always check the owner's manual for specific oil type and capacity.
There are 3 flat head screws to remove. One is at the rear of the passenger seat. one each under the side flaps of the seat. after removing the 3 screws, pull seat to the rear to remove from tongue.
To remove the starter on a RevTech motorcycle engine, first disconnect the battery to ensure safety. Then, remove any necessary covers or components obstructing access to the starter. Unbolt the starter from the engine casing and disconnect the electrical connections. Finally, carefully lift the starter out of its mounting position.
the trans fluid plug is a screw in plug near the oil dipstick. Remove that plug and it will have a dipstick made into it. That is the transmission fluid reservoir.
To change the brake pads on a 1999 Harley Davidson Fatboy, first, elevate the motorcycle securely using a stand. Remove the caliper by loosening the mounting bolts, then slide it off the rotor. Take out the old brake pads and replace them with new ones, ensuring they are properly seated. Reattach the caliper, tighten the bolts to the manufacturer’s specifications, and pump the brake lever to seat the pads before riding.
A 5/8" socket wrench.
remove the bolt at the rear of the seat and remove the seat. the battery is under there
how do I remove the front seat from a 1991 fatboy