To remove the speedometer sensor on a 1999 Harley Davidson 1200 Sportster, first, disconnect the battery to ensure safety. Locate the speedometer sensor, which is typically found on the side of the transmission. Use a socket or wrench to unscrew the sensor from its mounting position, then gently pull it out. Make sure to check for any wiring connections and disconnect them if necessary before fully removing the sensor.
Remove the Seat.
good instructions in the manual. I just removed mine to have it welded.
how to remover oil tank 1988 sportster
On a 2007 Harley-Davidson Sportster, the fuses are located in the fuse box, which is typically found under the seat. To access it, you'll need to remove the seat by loosening the bolts or fasteners. The fuse box cover can then be lifted off to reveal the fuses for various electrical components of the motorcycle. Always refer to the owner's manual for specific fuse locations and ratings.
There is a Hose with a Clip attached to the Left Side of the Frame underneath the Primary Cover. Remove the Clip and Pull the Drain Plug in the Hose..
On a 1995 Harley Davidson 883 Sportster, the fuse lock is typically located under the seat. To access it, you'll need to remove the seat, which is usually held in place by a couple of bolts. Once the seat is off, you should see the fuse box mounted on the frame, where the fuses are housed. Make sure to consult the owner's manual for specific details related to your model.
Remover the socket head cap screws from the fender struts and remover the tail light/ turn signal wiring from the tabs underneath the fender and you should be home free.
In my harley devidson its immobilizer lock could you told me how to unlock
how do you remove the back wheel on a 2005 Harley Davidson Dyna low rider FXDL
remove the seat
all you have to do is remove the 2 bolts where the motor mounts are which should be right above the horn. after removed take the bracket off and replace bolts and you will have successfully removed the horn assembly.
there is a square box on the left side of the motercycle. Just to the lower right of this box is a nut on a stud. Loosen this nut and the band that goes over the top of this box will loosen. remove the band, remove the top of the Chrome box, and remove the body of the box. And there is the battery.